How to remove the starter from a 1994 Pontiac Sunbird 20 liter?
autozone.com current vehicle choose car repair info vehicle repair guides u can go from there
Remove power connections from battery. Remove the wires to the starter. There are 2 bolts, one short, one long, that go from under the starter upwards. Remove these 2 bolts, loosing them each a bit at a time and holding the starter up to keep the turning easy. It is all basically a 'no-see' job, have to go by feel.
REMOVAL 2.4L 4-Cylinder Disconnect and isolate negative battery cable. Raise and support vehicle. Remove solenoid wire from solenoid terminal (STARTER ELECTRICAL CONNECTORS - 2.4/3.7L). Remove battery cable from stud on starter solenoid (STARTER ELECTRICAL CONNECTORS - 2.4/3.7L). Remove 2 starter mounting bolts (STARTER - 2.4L) and remove starter from vehicle. 3.7L V-6 Disconnect and isolate negative battery cable. Raise and support vehicle. Remove 2 flange bolts securing left exhaust downpipe to crossover pipe. Lower pipe…
For the 3.0 liter engine. Disconnect negative battery terminal. Locate starter at lower front of engine by engine fans. 2 bolts holding starter in, upper and lower. Remove lower bolt 3/4 way- easy to see, upper bolt go from top of engine to remove (need extensions). Completely remove lower bolt and remove positive battery connector and signal wire on top of starter. Install reverse of removal.
How do you change a starter on a 1993 S10 Chevy Blazer with a V6 4.3 liter engine and automatic transmission?
Where can you find step by step instructions and a diagram of how to replace the starter on a 1999 Dodge Intrepid 2.7 liter V6?
Can the solenoid be replaced without removing the starter on a 1998 Plymouth Voyager minivan with a 3 liter engine?
Disconnect the negative battery cable at the battery. Raise and safely support the vehicle. Remove the electrical connections from the back of the starter. Remove the bell-housing cover. Remove the starter support bracket bolt from the engine block. Unfasten the starter motor-to-engine bolts, then carefully lower the starter. Remove the nuts/bolts that hold the starter support bracket to the starter. To install: Transfer the starter support bracket to the new starter if the starter is…
Hard for home mechanic to do. You can mess up your timing just changing it. Best for this vehicle to go to the shop. Talked to 2 mechanics that I trust about doing it myself and both said, knowing my abilities to fix cars, that I'd best leave it to them. Just got my girlfriends water pump on her '94 Sunbird LE 2 liter replaced and after all the research I did I'm glad I…
Pontiac 3.8 liter engine the oil pump is crank driveni packed it with vasoline and still cannot get the pump to prime Is there another way to prime it?
Remove the oil filter and fill it with new oil. If problem still persist, then remove oil filter and use a oil squirter to squirt oil into the oil filter mounting base hold adjacent to the thread. Other ways to prime the engine is to rotate the engine with the starter with the fuel shutoff and no spark.