Nissan Maxima
How To

How to replace 2004 Nissan maxima camshaft sensor?

151617

Top Answer
User Avatar
Wiki User
Answered
2009-10-27 23:55:08
2009-10-27 23:55:08

Did you figure out where this sensor is located

123
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


where is the camshaft sensor in a 96 nissan maxima 3.0


On a 2005 Nissan Maxima where is the Camshaft Position Sensor (Bank 1) located?


How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin



It is located on the backside of the engine. Go to youtube and type in how to replace camshaft sensor on 2005 Nissan altima and it will show where it is and how to replace it, that is how I did my one.



where is the camshaft sensor on a 2005 Nissan altima


Camshaft position actuator A bank 2 usually means change the camshaft position sensor


location of the camshaft sensor


in the distributor, you have to replace the whole unit.


On the left hand side of the engine is the thermostat housing. The camshaft position sensor is located directly above the thermostat housing on the end of the cylinder head.



The camshaft position sensor is located on the timing chain cover at the front of the engine.


Its on the passenger side of engine around the timing area... 10mm bolt... and a clip connector


What problems will a bad speed sensor cause on a 1999 Nissan Maxima


Where is the camshaft position sensor located on a 2003 Nissan Sentra GXE?



The camshaft position sensor is located near the thermostat housing. You should replace the crankshaft position sensor as well. This one is much harder to locate....it is on the backside of the engine that is between the firewall and the engine block. Both use the same sensor.


In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.


Your blower switch sensor is out. Replace it!Then all the speeds will work



where is the cam sensor on 2002 Nissan frontier 3.3 v6


The Camshaft sensor is located under the cap and rotor of the distributor. This is a common failure on the 2.4L engine due to oil leakage into the distributor. how is the camshaft sensor replaced on 1995 Nissan altima. what other considerations are there.


the camshaft sensors are located on the back of the heads under the air cleaner duct.




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.