A blower resistor can be replaced, in your 2002 Oldsmobile, by removing the resistor wiring. Remove the retaining screws. Reverse the process to install the new resistor.
It is on the evaporator case and is held in with 2 screws.
how to replace blower resister on a 325i BMW 2002
To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.
Ask a guy
this resistor is located next to the blower motor in the heater plenum. the coils sit in the air stream. remove the connector and the fasteners and pull the resistor block out.
The blower resistor is located under the dash, near the floor, on the passenger side of the vehicle. I had to replace the resistor about a year ago. It is not an easy place to work in. You have to remove the blower unit in order to get at the resistor. Not fun, but rewarding when you actually do it yourself.
the blower motor resistor is located behind the blower motor which is located behind the glove box there is clip wires you need to disconnect and then connect the new one.
By the clutch pedal two screws and a plug
Short of it is the resistor controls the fan speeds for the blower. Easy to replace and to my knowledge only available through a dealer.
Generally the blower motor resistor is found close to the blower motor. It relies on the blower motor to keep it cool.
Replace the Blower Resistor which is located behind the glove compartment. This is a common problem.
The fuse. The blower motor speed resistor. The blower motor relay. The blower motor switch. Check for power at the blower motor connection.