Cars & Vehicles

Where is the blower motor resistor of a Mazda mpv 2002?

012

Top Answer
User Avatar
Wiki User
Answered
2015-08-13 11:17:10
2015-08-13 11:17:10

Generally the blower motor resistor is found close to the blower motor. It relies on the blower motor to keep it cool.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


where is the blower motor resistor located on 2002 gmc envoy?


To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.


I have a 98 olds intrigue and the blower motor resistor is located under the glove box behind the blower....


It should be called the auto HVAC blower motor resistor wire harness. Goes from the auto climate blower motor resistor to the blower motor.


Under the glove box between the firewall and the blower motor




the blower motor resistor is located behind the blower motor which is located behind the glove box there is clip wires you need to disconnect and then connect the new one.


The Blower Motor has a resistor attached to the blower motor itself. I'm not familar with a relay for the motor. I think you have to remove the Blower Motor itself to get access to the resistor. The blower motor is under the dash on the passenger side. It's like 3 maybe 4 bolts to remove.


sounds like a bad blower motor resistor and or plug


The fuse. The blower motor speed resistor. The blower motor relay. The blower motor switch. Check for power at the blower motor connection.


this resistor is located next to the blower motor in the heater plenum. the coils sit in the air stream. remove the connector and the fasteners and pull the resistor block out.


It is usually ( at least on a 2000 Ranger) locted on the blower motor housing in the engine compartment.


how to replace heater fan resistor on Nissan Sentra 2003



I would suspect the blower motor speed resistor is bad.



it is under the clove box behind the blower motor you will see it if you look its a black box


Blown fuse, defective blower motor, or defective blower motor resistor pack.


I have been working on an issue with my 2002 Dodge Ram. The blower motor and resistor are both located on passenger side under the dash. Easily accessible in cab.


When the fan is on high it does not run through the blower motor resistor. The low speeds don't work because the blower motor resistor is bad.


The resistor is located on a duct behind the glove compartment and the glove compartment back.



The blower motor resistor is a $35 part and is easy to do it yourself. It is behind the glove box and easily identified by the wires running from the blower motor over to it. For a complete "how to" come join out free enthusiasts forum at www.trailvoy.com


First locate the resistor, it is under the hood, on the firewall, passenger side, close to the blower motor. Unplug the wire connection and remove the three small screws holding it in place, then remove the resistor.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.