answersLogoWhite

0

When replacing engine internals, it is crucial to torque everything to the exact specifications, therefore you will need to purchase a repair manual that covers major engine overhaul. In doing so, you will have the exact instructions on how to complete the project.

User Avatar

Wiki User

20y ago

What else can I help you with?

Related Questions

How do you replace front brake pads on a 1992 Pontiac Transport?

With a wrench.


Where is the relay for a 1992 Pontiac transport?

Where is the fuel pump relay on a 1992 pontiac transport van


How do you replace ignition switch on a 1992 Pontiac Bonneville?

How do you replace the ignition swith opn a 1992 Pontiac Bonneville se


Where is the crank sensor for a 1992 Pontiac Grand Am?

The crankshaft sensor is on the side of the engine behind the alternator. It is mounted close to the oil filter,


What tools are required to change the front brakes on a 1992 Pontiac Transport?

Visegrips, a cigarette and beer.


How do you replace a heater core in a 1992 Pontiac firebird?

remove the entire dashboard.


Where is the turn signal flasher on a 1992 Pontiac Transport?

Look under the dash on the left of the steering column.


What is the next step after replacing the ignition module on a 1992 Pontiac transport with no spark?

May be coil pack


Location of crankshaft position sensor on a 1992 Pontiac sunbird 2.0?

It is located on the side of the block next to the radiator, just above the A/C compressor.


Where is crankshaft sensor on 1992 Pontiac Bonneville?

my son just replaced one on my car i also have a 1992 Bonneville it is located on the passenger side frount behind the tire you will need to remove your tire


How long does it take to replace the water pump on a 1992 Pontiac Firebird 305?

about 2 hours


How do you replace front door latch on a 92 Pontiac transport?

To replace the front door latch on a 1992 Pontiac Transport, first, remove the interior door panel by unscrewing any screws and gently prying off clips. Once the panel is off, disconnect the wiring harnesses and remove the bolts securing the latch to the door. Replace the old latch with the new one, reattach the bolts, reconnect the wiring, and finally, reassemble the door panel. Test the latch to ensure it functions correctly before finishing up.