answersLogoWhite
Chevy Tracker
Check Engine Light
Geo Tracker
How To

How to reset check engine in 1998 go tracker?

202122

Top Answer
User Avatar
Wiki User
Answered 2005-09-01 07:18:01

Try disconecting the battery post for a bout 4 hours, and it should reset the computer on the car.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


A quick way to reset the check engine light would be to disconnect the battery for a short while


To reset the check engine light on a 1998 Honda Civic located the blue 15 amp fuse in the engine bay fuse box. The fuse is labeled ECU, and will reset the check engine light when removed.


I reset the check engine light on my jeep by disconnecting it from the battery.


You can reset the check engine light, on your 1998 Land Rover, by repairing what ever is causing the light to stay on. You can determine the cause by using a diagnostic tester.


After repairing the cause of the code, you reset it with a scan tool.




Just disconnect the battery for couple minutes.



There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.


The check engine light on the 1998 Buick Park Avenue can be reset by disconnecting the battery for a few minutes and then reconnecting it. The check engine light is only going to stay off if the problem that created the light is fixed.


You have to plug it into a computer/diagnostics machine for it to reset. Also, you will see that the code for your problem is fixed, or not.



Disconnect the batter for 30 seconds and this resets the computer.


correct problem then dis connect and reconnect battery.


After repairing the cause of the code, you clear the code with a scan tool.


you need access to an OBDII scan tool in order to reset the check engine light on any vehicle 1996 or newer. autozone or advanced auto usually provide this service for free


if you are looking to reset a check engine light or any trouble codes, you will need to have it done with an OBD2 handheld scanner.


There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.


If the check engine light is on, there's something wrong with the engine. Or, the computer is bad. One or the other. They don't set a light for no reason.


You need a code reader to reset & plug into port.



you can get it reset by a parts shop or just unplug the battery may one or 2 hours, but make sure you check what was the problem and got it fix


You can disconnect the battery although this is not recommended. You can also use a code reader to read and reset the codes. If you fix the issue, it should reset by itself.


You reset it with an OBD2 scan tool after repairing the problem detected by the computer. Otherwise it will just come back on.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.