Yes. Since the coil is run at full voltage when starting 12 volts may be too much for a 6 volt ignition coil. It would be at about 8 volts when running. There is a starting resistor.
black
"What type of capacitor use to stabilize a 12 volt car when the voltage drops and how to wire?"
Parallel.
no volt coils are used to de-energise a contactor should a situation arise in which voltage is zero
12 volt.
red wire goes to 12 volt when key is on,black to ground,blue to either 12 volt key on or it really needs to tie into light switch because that is what it is for and the green wire goes to negative side of your coil
Probably not much because 6 Volts is not enough to power a 12 Volt coil
Yes. Since the coil is run at full voltage when starting 12 volts may be too much for a 6 volt ignition coil. It would be at about 8 volts when running. There is a starting resistor.
what is the number of turns in the primary and secondary coil for 12 volt battery charger with 220 volt power supply> what is the number of turns in the primary and secondary coil for 12 volt battery charger with 220 volt power supply>
If you are talking about the compressor clutch coil windings then connect one wire to from the coil to ground and the other wire to a 12-volt source, the coil will become magnetized and will be able to put up a heavy piece of metal or you can use a ohm meter as well..........
Which wire theres 2....... 12 volt all the time and 12 volt switched?
can 6 ,12 volt battery be wire to make in to one 24 volt battery for solar use in home
black
"What type of capacitor use to stabilize a 12 volt car when the voltage drops and how to wire?"
The gauge of wire that is 12 volt is 18, 14, and 16.
wire it in series