0
You have to walk before you can run.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How run electrical from house to a shed?
You will have to run wires from your electric box in your house, I would suggest barring these wires.
Would 350 small block run with the firing out of order?
With two wires crossed it would run, poorly but it would run. With four or more wires crossed, probably not.
What wires are only needed for the engine to run on a 1995-2005 Chevy Cavaliers?
The 10.2mm spark plug wires are the wires that are only needed for the engine to run on a 1995-2005 Chevy Cavaliers.
Will a car run if plug wires are crossed?
If two wires are crossed it will run, poorly but run. If more than two are crossed it probably won't have enough power to move the vehicle if it runs at all.
What is a good tool to run wires behind walls?
A good tool to run wires behind walls is a wire puller tool. The wire puller tool has a long pole on the end for pushing and pulling th wires.
How do you run spark plug wires?
top to bottom
What two color wires are the iat maf wires for a 2000 5.3 chevys?
what color are the wires that run my iat on a chevy silverado 2000 5.3 2wd.
Putting in a new kenwood system in 05f150like to know if you should run new wires from amp or use exsiting wires IF you need to run new what gaugeand what gauge are the wires from factory system?
use the existing wires you only need to change the gauge of the wires if amp is 500+ watts if less watts there not much difference in sound quality
Where are the speaker wires run on a 1991 camaro?
to my stereo deck
How do you run spark plug wires on a Chevy 350?
change only one wires at a time,matching each to length.
How do you wire a 220 volt motor with 6 wires?
you have to ohm out the wires the start windings will have a higher resistance and the run windings will have a lower resistance if you have 6 wires then you may have a dual motor 1start winding and 2 run windings each having 2 wires the start windings and the run windings are all hooked up in parallel with the start capacitor hooked up in series with the start winding
Is it recommended to run new speaker wires when installing new speaker?
no
