0
In order to replace the fuel gadge you will have to remove the dash piece surrounding the gadge cluster/ tachometer/etc. there is a few bolts and screws but once you are able to access the gadges its as easy as unplug remove and replaceing the specific gadge the labor around removing the dash takes a few but after you remove the bolts underneath and afew to the sides and above you will get r done
What else can I help you with?
Where is an 1988 Mazda 626 fuel pump relay located?
On a 1988 Mazda 626, the fuel pump relay is located in the fuel tank. Always disconnect the battery before beginning work on a fuel system.
Where is the fuel pump for a 1988 Mazda RX-7?
it is located in the fuel tank
Fuel tank capacity of a 1988 Mazda RX 7?
50L
What is the fuel tank capacity of 1988 Mazda RX-7?
16 Gallons
What type of fuel pump for 1988 Mazda 323 sedan 1.6 liter no turbo throttle body fuel injection?
The 1988 Mazda 323 1.6L non-turbo EFI engine requires an electric fuel pump, which is located inside the gas tank.
Where is fuel pump located on a 1988 Mazda RX7?
In the fuel tank . Inside. Access through round plate on floor in boot.
Is a 1988 Mazda 323 carburated?
No, the 1988 323 is fuel injected. Are you needing to service the car? if so what needs doing? Cheers Malcolm
What is the fuel tank capacity in a 1988 Mazda MX-6?
The fuel capacity for the first generation MX-6 is 60 Litres, or 15.9 Gallons.
Where is the fuel pump on a 1988 Mazda rx7 turbo?
In the fuel tank. can be removes from the trunk of the car. just lift up the carpet.. it will be on the left side
Where is a diagram of a 1988 Mazda MX6 fuel pump relay?
You can find a diagram of the 1988 Mazda MX-6 fuel pump relay in the vehicle's service manual or repair guide, which often contains detailed electrical schematics and component locations. Additionally, online automotive forums, websites like Mazda enthusiast pages, or platforms like Haynes and Chilton may offer downloadable diagrams. Searching for "1988 Mazda MX-6 fuel pump relay diagram" on Google Images can also yield useful results.
Where is the fuel pump wiring go on a 1988 Mazda RX7?
In a 1988 Mazda RX-7, the fuel pump wiring typically runs from the fuel pump located in the fuel tank to the fuel pump relay in the engine bay. From the relay, it connects to the fuse box and then to the ignition switch, allowing the fuel pump to receive power when the engine is cranked. It's important to consult the vehicle's wiring diagram for precise routing and connections.
What is the capacity of fuel tank in 1988 Mazda 626?
The fuel tank capacity of the 1988 Mazda 626 is approximately 15.9 gallons (about 60 liters). This capacity may vary slightly depending on the specific model and configuration, but it generally falls within this range. Always refer to the owner's manual for precise specifications.
