Want this question answered?
23
Rafters are 16" on center. Trusses are 24" on center. Or 450mm & 600mm australia
For wood framing it can be 16", 19 1/4" or 24 " on center.
You still need to indicate the pitch, the roof sheathing, and the shingle weight.
Rafters are usually on 2 ft. centers.
23
Rafters are 16" on center. Trusses are 24" on center. Or 450mm & 600mm australia
For wood framing it can be 16", 19 1/4" or 24 " on center.
If you had a 4/12 pitch and the ridge was running the 20' direction and you were planning on a 12" overhang, your 2x6 rafters would be just shy of 9'-6" each. If your framing is 16" on center you will need 34 of them.
You still need to indicate the pitch, the roof sheathing, and the shingle weight.
I would check the facia board for nail heads. The rafters/trusses are 16" or 24" o.c. If you can find protruding nail heads in the facia and measure the distance between two of them, you can determine where the rest are.
You can see the rafters of the roof very clearly here.
At the peak of the roof where the rafters meet instead of the rafters meeting each other, there is a beam between them that they rest against. It runs the length of the roof peak.
The pitch of a roof is measure in a simple way. Rise over run. By this it means that, given the standard example of a 4/12 roof ,for every 12 inches or one foot of distance or run there is an according rise of 4 inches in height. If you wish to determine this you need to know the length of the rafters and then the height from the center of the rafter to the peak of the roof. For instance if the rafters happen to be 24 feet long that means that the run is 12 ft and if the height from the bottom of the rafter to the peak is 8 feet then you have a 8/12 pitch roof.
To seal the ridge from weather. If a ridge vent is used it is just that, a vent for the roof.
in need of rafters on my roof,before i can have it weatherized
A purlin is a structural part of a roof which is used to support rafters and carry the roof cladding By supporting the rafters they allow for longer roof spans to be created allowing for wider buildings to be created.