0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace the rear main seal on a 1995 Chevy Suburban?
You must first remove the transmission and fly-wheel. Then you will see the 1 piece seal on the crank shaft. Pry it out, it will pop out. Then install new seal in it's place. A seal driver is the best tool to use. Be sure you clean the area good, and put some oil on the crankshaft before sliding the seal over the crank.
Will using the wrong weight of oil cause the crankshaft seal to blow out in your 2006 PT Cruiser?
Very thick oil such as 20w50, maybe. The crank seals on a 2.4L do pop out once in a while.Very thick oil such as 20w50, maybe. The crank seals on a 2.4L do pop out once in a while.
Why is your kx 125 leakin oil from the front sprocket?
Bad seal. Drain oil, take front sprocket off, pop old seal out, clean out making sure any dirt and grit is removed before installing new seal.
How do you replace a main front transmission seal on an 1985 trans am?
The tranny has to be taken out of the car or back far enough to get to the seal, just pop the seal out with a screwdriver and tap a new one in place with a hammer.
How do you change the front automatic transmission seal on a 1994 Chevrolet Camaro V6?
you will have to pull the tranny out to change it and then you can pop it out with a screwdriver.
How do you get off the window crank on the front door of a 1997 Saturn SL2?
Saturn Shop Foreman here, old school GM window crank remover or use a shop rag behind the crank to grab the tangs of the clip and pop it out, it will fly like the wind if you don't watch out!
Who sings watch me crank that batman?
pop it off boyz
How do you change front seal on transmission on 1997 Chevy s10 4x4 blazer?
you have to un bolt engine at the bell housing where the engine and trans meet and and un hook wires from trans loosen or remove mounts un hook drive shaft and slide trans back be careful and check if any vacuum lines to to the trans too if vac lines go to trans u have to un hook them as well take torque converter off and then u can get to the front seal u pop the front seal off and pop a new one in then hook every thing back up and it is done
How do you replace crankshaft seal in a dodge caravan?
Should pull the drive pulley and then you can pop off the old seal with a screw drive and press in the new seal.
How do you fix a shift seal leak from a motorcycle?
get the new seal from your local shop or online Remove the shift linkage/shift lever, use a pick or small flat head driver to pop out the old seal, clean the shifter shaft and case opening. oil/grease the new seal and pop it in with the open side faceing the motor
Who wrote the song 'Crank Dat Batman'?
The song "Crank Dat Batman" was wrote by the group "Pop It Off Boyz". They got the idea of this song from the writer of the song "Crank Dat Soujla Boy".
How do you tighten a 3 piece crank on the donny Robinson hyper bike?
Pop the cap out of the center of the crank arm and tighten with a 14mm socket. Replace cap when done.
