answersLogoWhite

0


Best Answer

Without any knowledge of the entire process or the type of rock you are using, and assuming standard practice, try putting pieces of leather [about one inch square,roughly] in the polish cycle. After the polish cycle, run the rocks in cheap dry laundry soap and water mix, about the thickness of pancake batter. Again put leather pieces in with it, fresh leather, not reused from the polish cycle. Run this cycle the same length as the polish cycle. Use any scrap leather available in a volume of about 1/3 that of the rock. We use this procedure with every batch and get good results.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: I'm having problems with my rock tumbler my rocks are not mirror shine what could be the problem?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix the sun roof on 2001 Volvo s60?

What do you mean "fix"? Give us a bit more detail of the problem it looks like don't have powered,,, the trunk don't open aider I have to use the key Some of the s60's have a valet lock out button on the dash to prevent the trunk from being opened with the remote. However since you are also having sunroof problems I suspect you are having a problem with the UEM (upper electrical module) that is part of the mirror. Are you also having problems with your remote controls for locking and unlocking the car


What are the advantages of a cordless beard trimmer?

When trimming a beard, the cord can often get tangled. Another problem with having a cord on a beard trimmer is the cord may not be long enough to comfortably reach from the socket to the mirror. A cordless beard trimmer eliminates both of these problems.


How do you tighten a loose mirror on a 97 dodge ram?

I have a 96 Dodge Ram with same mirror problem. Started after about 135k miles. Dealer said they just "wear out" and they need to be replaced. They are OK under 60 mph, but after that they both turn in. If I do replace, I will go with power mirrors to prevent future problems. you dont need to replace the mirror! take the cover off the mirror where it attaches to the door and the problem will be easy to see. But how do you remove the cover?


How do you tighten a outside mirror on a 94 Chevy c1500?

inside the truck on whatever door you are having the mirror problem with will be a little panal connected to the dash. Take the panal off and you will see a screw right there and it should tighten in a jiffy


What problems have there been with the hubble telescope?

the mirror was not right


What is the best mirror files service?

I've been using mirrorcreator for quite some time, but they are always having tons of problems with their mirrors and their servers. Because of that I would recommend you using uploadmagnet service. They are proving popular mirrors and I didn't notice even one problem with them. Try it, it's free and if you want more options they have also a premium option. Visit this link to <a href="http://www.uploadmagnet.com">mirror files</a>.


Why is situs inversus not a problem?

Yet because this arrangement, called situs inversus, is a perfect mirror image, the relationship between the organs is not changed, so functional problems rarely occur.


What is the problem with using convex mirror as wing mirrors on cars?

The images in your mirror will be closer than they appear


What is an antecedent problem?

It could refer to the mirror or the shelf.


What is a Mirror Mustache?

Mirror Mustaches are vinyl mustache decals that give someone the appearance of having a mustache when they look into a mirror. These can be found onhttp:/www.mirrormustaches.com.


Why would no power be going through the wire to the inside rear view mirror on a '97 Toyota Avalon XLS?

I have a 95 XLS that had the same problem. Also had problems with intermittent dash lights in the lower AC controls area... The mirror wire had an intermittent connection in the fuse/junction box area on the lower front area by the drivers feet. I pulled on the wires and the 12+ appeared at the mirror. It has since gone out again and I just gave that panel area a couple of kicks with my left foot and it came back again. Guess there is a flaw in the connections down there - I thought I was the onlt one having that problem. Hope this helped.


What problems did the Hubble space telescope face when it was in space?

launch delays, budget problems and a incorrect mirror