i have no idea
Start by checking the fuse. If the fuse is good, apply 12 volts directly to the blower motor. If the motor runs it is good. Check all the wiring for loose or burnt wires. If all this checks out, then the Blower Motor Resistor Pack may be defective, or the blower motor speed switch itself.Start by checking the fuse. If the fuse is good, apply 12 volts directly to the blower motor. If the motor runs it is good. Check all the wiring for loose or burnt wires. If all this checks out, then the Blower Motor Resistor Pack may be defective, or the blower motor speed switch itself.
25
Generally this will be possible. To keep the motor energized correctly you need to keep the volts per hertz roughly at nameplate (so 7.6 volts per 1 Hz). 460/60 = 7.66 volts per hert. I would still verify with the motor manufacturer that it is OK to use in the fashion you are planning, though.
12 volts
A motor will operate on 400 volts.
You should not go above 240 volts for that type of motor.
12 volts
what is the full load amps for 2.4 hp motor at 460 volts ?
Depends on the ratings(volts, amps, etc.) Definitely not an AC motor.
Watts = Volts times Amps. Therefore, if the voltage was 220 volts, the motor would draw 500 amps. If the voltage was 4,000 volts, the motor would draw 27.5 amps. The voltages for large powerful motors tend to be relatively high, for example in the 380 Volts to 11,500 Volts range.
No, unless the motor was wound for dual voltage operation, which it will state on the motor nameplate, a 110 volt motor run on 240 volts will be damaged.
A circuit board is the inducer motor. It runs off of 120 volts.