The regular switch just connects in the circuit the same way as the dimmer switch came out. If the dimmer switch had its own wires the only difference will be is you will have to supply your own wires from the new switch to the existing connection. IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS. If you do this work yourself, always turn off the power at the breaker box/fuse panel BEFORE you attempt to do any work AND always use a meter or voltage indicator
to insure the circuit is, in fact, de-energized.
The rating of the main switch is decided upon by the current incoming mains. The main switch can't be lower than the incoming. In order to upgrade the main switch, the breaker box will need a complete upgrade.
Yes
Probably not, since a volume control switch is designed for extremely low current measured in fractions of a watt, while a dimmer switch is typically capable of handling several hundred watts.
You need a three way switch to control lights from two locations. The name is misleading. Three way switch refers to the connection points on the switch. You can use a three way switch as a single switch as long as you place hot wire on the brass screw and the use any of the other screws for the return hot.
This simple if you have two switches controlling a set of light you will need to buy a three way switch. A three way switch will have a place for three connection. Depending on what brand of switch you purchase the directions will be sightly different but most dimmer come with detailed directions and diagrams. When you by a dimmer you need to read what kind of load it is meant to control. They are built to control incandescent light, magnet low voltage lights or electronic lights.
It is very simple to install a dimmer switch in place of a regular light switch.
No, the dimmer switch needs its own individual circuit power supply to feed the fixtures connected to it. The black of the second dimmer switch can not be connected to the red wire of the first dimmer switch. Now if you are talking about using a common "hot" to feed two dimmer switches then this can be done. The neutrals will be common also. So what you should have is two black wires connected together with the incoming "hot". Two neutrals connected together with the incoming white. The red from each dimmer is then connected to its own individual fixture load.
The dimmer switch is said to be included with the steering column switch. Before replacing disconnect battery and removing steering wheel. After removing the steering column switch trim, unscrew hex bolt. Remove and replace switch and return components.
One of the things to do is if your ceiling fan is being operated by a dimmer, set the dimmer to the highest setting to stop it from humming or replace the dimmer switch with a regular wall switch.
Dimmer switches go bad, more often than regular switches.
120 volt xenon bulbs are fully dimmable just like a regular incandescent bulbs, using regular old 120 volt dimmer switches.
No a switch just opens and closes a circuit. A switch can be replaced by a dimmer switch. The dimmer switch will fit in the same enclosure that the switch is removed from.
dimmer switch dimmer switch
I would suspect the dimmer switch or "combination switch".
The 1993 BMW 325 dimmer switch is located on the lower left-hand side of the dashboard. The dimmer switch is a dial switch.
The dimmer switch is located near the floor on the left side of the steering column. The dimmer switch and ignition switch are secured by the same two screws. The dimmer switch will be the one on top. Loosen and remove the screws, disconnect the wiring harness from the dimmer switch and replace with the new switch, complete the assembly in reverse order.
How do I change the dimmer switch on my 1993 corvette?