The shaking might be due to wheel imbalance and the pulling due to poor wheel alignment.
Could be a number of things upper and lower ball joints,wheel bearings,warped rotors,bent rim, tire out of balance etc.
Check tire balance or wheel bearings in front axle
You did not say what year it was, and that makes a difference. But you can check these things--- U-joints in front drive shaft, Front CV joints and axel shafts.
Probably bad u-joints in the front. Had the same.
If you grab it in the 12 and 6 o'clock positions, you are typically checking for play in wheel bearings and ball joints. If you grab it in the 9 and 3 o'clock positions you are typically checking for tie rod ends or wheel bearings. But you are not totally limited to these although the most common.
yes. They have shake junt abec 6 bearings.
out of round tires, needs balanced ,bad wheel bearings ,need more info; 65
There are a number of things that I know of that can cause this one. First off did you have an alignment done after replacing the tires? I would also suggest checking out your front end ie ball joints, tie rod ends, wheel bearings and so on. Good luck
check your wheel bearings and if they're ok check your cv joints by jacking up the front of your car and rock your tires forward and back to see if they clunk or shake pretty good
Track bar joints worn out.
front rotors or loose ball joints
a shake in the steering wheel could be a few things,a bad rim,broking belt in one of front tires,aliment,ball joints,or could be all of these thing Could be as simple as wheel balance but have the front end checked by a mechanic to be safe.