Try using some rad flush for 2-3 days, then drain water and refill with fresh, make sure you have no blockages, if this fails, check the water pump for worn impeller blades.
Heater core (radiator) needs to be cleaned or changed
The radiator can be flushed with water running continuously. This will flush out any loose particles. The only way to completely clean the radiator is to have is professionally cleaned in a chemical bath.
it is a place that you stay that is not cleaned or the sheets are not changed by a cleaner
If it is clean, undamaged, and in good working condition.....NO. Since the radiator needs to be removed, to remove the engine, now is a good time to have it cleaned and checked.
Intake manifold gasket leak? (Never heard of a heat sensor). Many possibilities.
Yes
The water pump on a 1994 Chrysler Concord is changed by removing the engine accessories, disconnecting the radiator hoses, and unbolting it from the engine block. The surface is then cleaned, a new gasket installed, and a replacement water pump mounted.
Some air purifiers do require a filter to be changed others have a filter that can be cleaned.
Remove The Radiator And Take It To a Good Radiator Shop. Most Likely Yours Can Be Cleaned And Repaired. When You Reinstall It, Add New Antifreeze Plus Water Pump Lubricant. This Will Help Stop Corrosion. Good Luck
my 1991 b2200was overheating until i removed the radiator and sent it to be cleaned, problem solved.
It's possible. A build-up of sludge can plug up parts of the radiator core and make it lose capacity. Sometimes they can be flushed and cleaned to improve performance.
Typical problem caused by a blocked radiator,i had a similar problem on my '94 ballade,had radiator cleaned out by specialists...solved my crisis now running into a full year without water spilling over.Good luck.