0
I have a 1990 Volvo 240 dl fault codes 2-3-2 and 1-1-3 from socket 2 and 1-1-1 from socket 6 and how do you clear them?
Wiki User
∙ 12y ago
Hi,
2-3-2 (if rich) means most likely a leaky fuel injector.
1-1-3 means it's too rich or lean at idle (upper limits of what it can compensate for).
To clear codes, after reading the codes, hold in the button for about 7-10 seconds.
Then wait, you will now se a continuous light.
Then again, hold for 7-10 seconds.
When this is done, try to again read codes (hold for max. 3 seconds).
It should now say 1-1-1 (meaning no faults).
Another way to clear them, is to remove the battery for about 15 minutes.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do fault codes clear on a 1997 Ford F150?
Auto Zone will check your computer codes for FREE... They can also clear them.
How do you clear fault codes for Daewoo matiz?
Try disconnecting the battery for 20 minutes then reconnect.
How do you erase Airbag fault code in a Volvo S60?
You will need to go to a dealer or a repair facility that has the Volvo Vida diagnostic computer with the Dice interface. A average diagnostic tool cannot access the SRS codes.
How do you read the fault codes on a n16 pulsar?
1996 nissan pulsar fault codes
Does Volvo have an insurance policy if you die in a Volvo by accident?
Volvo is not liable for your death unless it is due to a deficiency or defect in the vehicle which is due to the fault of Volvo.
Fault code p 1080 what is it?
basically, p 1080 is a fault code that faults many codes, it faults codes that is a code for a fault, when you get a faulty code you need to un fault it with a code called p 1080, which is a fault code that measures fault codes!
What are the computer fault codes I have A reader but lost the book?
I need to know the computer fault codes I need numbered bios codes and not bleep codes
How to Clear codes on 2003 dodge ram 4.7?
Repair the component that set the fault code, and then reset the ECU with an OBD2 scan tool.
How do fault codes clear on a 2004 trailblazer?
On this vehicle, it can be done with the OBDII machine or, usually, if you fix the problem, the light will go off on its own
How do i remove the engine management light in your Ford Fiesta?
Plug a laptop or code reader into the diagnostics socket, find out what the fault is, or was, clear the fault if it's still on or cancel the alarm thereby turning out the fault light if it's just a transitory fault which has already cleared. If you're in the AA or RAC, call 'em out to do it.
How do clear the computer fault codes so that the Power Loss light will turn off in a 1986 LeBaron?
You need to have it checked for codes with a scan tool, otherwise unhooking the battery will erase the codes until the mafunction happens again.Disconnect battery
How do you reset citroen c3 engine light?
you will need to plug in an obd diagnostic scanner to read the fault codes then clear them which will turn off the light
