0
I have a 85 oldsmobile cutlass and I was driving and the car made a loud noise and the car stop pulling, what could be the problem?
Wiki User
∙ 15y ago
i think better to change the engine oil for that one.for better results consult your nearest mechanic.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Why is the car losing pulling power when driving?
Have you checked the lambda probe? It is a few hundred quid but fixed the problem for me. Get a garage to run a diagnostic to check that this is the problem before you get it done.
1975 Oldsmobile cutlass would a bad radiator make the car feel sluggish and over heat. When you drive it it feels like your pulling a trailer or something. Any ideas?
A bad radiator could be the cause, or the car might have a blown head gasket which would cause it to overheat.
Theres no first or reverse in ford windstar axod metric transmission even after filter and fluid change?
Customer had a similar problem with a 99 Windstar. Stopped pulling while driving it. Had it towed to me and I replaced the torque convertor. Problem fixed.
Why do cars feel like its pulling while driving?
umj. jjk
How Remove heater blower on an Oldsmobile cutlass ciera 1993?
If it is the same or similar to an 87, there are a few small bolts holding the motor in place in its duct on the firewall (on the engine side), near the passenger side of the vehicle. Depending on the engine, getting it out may be a little difficult. There are also wires attached to terminals on the motor that must be removed by gently pulling them off.
How do you diagnose brake problem on a 1995 mercury sable?
What kind of brake problem(noise,pulling)?
How do you change the turn signal switch on cutlass?
If its a Olds Cutlass Supreme, its a fairly easy process. Grab the turn signal stalk firmly near its base. Gently wiggle, and slightly twist while pulling it out. Replace with the new stank and plug in the small plug at the base of the stalk. And your done If you are talking about a Olds Cutlass Ciera, its not a easy process, and I pay to get it done.
Should I use overdrive when driving Dodge Durango?
Yes, unless you are pulling a trailer.
How much will a ticket be for driving in the wrong lane while pulling a small trailer in Pasadena CA?
how much for going 70 mph while pulling trailer
How do you repair a clutch valve in an Olds Cutlass and also what would cause RPM's to increase as speed decreases?
Your car if its a stick is not pulling out of gear all the way and your moter overrevs
How do you replace the rear license plate bulb on a 1996 Olds Cutlass Supreme?
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
How do you remove a center dash in a 1986 Oldsmobile Cutlass Supreme to remove the stock radio?
I found the easiest way to do remove the woodgrain faceplate is to take a small scewdriver, and bend the end of it until it is hooked shaped, then put the hook behind the faceplate one corner at a time, slowly pulling out until each corner pops loose. Its the best way I know how, I have took many off this way with no damage to the faceplate.
