answersLogoWhite

0


Best Answer

I found the easiest way to do remove the woodgrain faceplate is to take a small scewdriver, and bend the end of it until it is hooked shaped, then put the hook behind the faceplate one corner at a time, slowly pulling out until each corner pops loose. Its the best way I know how, I have took many off this way with no damage to the faceplate.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove a center dash in a 1986 Oldsmobile Cutlass Supreme to remove the stock radio?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Music & Radio

How do you remove factory radio on 1996 Oldsmobile Eighty Eight?

u take the wood trim off from the dash pop it out and turn two screws in the glove box then take out two more screws from under the center dash piece near the ash tray then there is acouple more srews holding the radio in and unplug it o and if u have a theft lock system deactivate it opppss!


How do you remove the radio from a 1992 Lexus SC400?

You have to remove the center dash panel to get access to the bolts, screws.


How do you get to the radio for 2001 Lexus gs300?

the radio is below the center of the windshield, right below the air vents... If you mean how do you REMOVE the radio then that's another question altogether. PULL out center air vents, REMOVE ashtray, there are 2 bolts there and 2 where you removed the air vent. Remove those and your there.


How do you remove a Toyota Sequoia radio?

Easy job on the 2002. Turn the two center air vents down and look inside above them. You will see a screw in each. Remove the screws and the face plate will come off. The radio is then bolted into the dash and can easily be removes. I hope no car radio theives are reading this!


Wanting to swap out an 07 Ram REF radio with a RAK radio is there some detailed instructions on how to remove the existing radio anywhere?

I have detailed step by step instructions, along with pictures, on how to remove your dash and center console for the 07' Dodge Ram 1500 Laramine package. These instructions are for the center, non flip down style, console. Please e-mail me at jdhoff87@yahoo.com if you want me to send the Word document to you. I knwo how it was to figure out how to do it with no instructions, so I know your hassel.

Related questions

How do you remove a transmission from an Oldsmobile cutlass supreme?

what are the steps to take off transmission from a Oldsmobile cutlass supreme


How do you remove factory stereo 1998 Oldsmobile cutlass supreme?

Oldsmobile didn't make a Cutlass Supreme in 1998


How do you remove front fender 87 cutlass supreme?

how do i remove the front fender to 1996 Oldsmobile cutlas supreme.


Where is the thermostat in 1997 cutlass?

Where is thermostat on 97 Oldsmobile cutlass supreme 3.1 Liter. How hard is it remove.


How do you remove a fender for a 1981 Oldsmobile Cutlass Supreme?

Take out the screws that hold it on.


How do you remove the govenor on a 1996 Oldsmobile cutlass supreme?

its computerized ma man.


How do you replace a thermostat on a 1985 Oldsmobile Cutlass Supreme?

First, remove the thermostat housing. Then grab the thermostat by hand and remove it.


How do you access the fuel pump on a 1993 Oldsmobile cutlass supreme?

inside gas tank,remove tank.


Where is the radiator fan relay on a 1996 Oldsmobile Cutlass Supreme?

Check on the passenger side firewall may have to remove plastic cover


Where is the antifreeze drain plug on a 1994 Oldsmobile Cutlass Supreme?

Bottom of radiator. If it has none then remove the lower radiator hose to drain the radiator.


How do you fix the outside door handle on a 1993 Oldsmobile Cutlass Supreme 2 door?

To fix the outside door handle on a 1993 Oldsmobile Cutlass Supreme 2-door, remove the trim and access the mounting screws. Remove the nuts and disconnect the linkage rod by flipping the small clip and sliding the rod out of the handle. Reverse procedure for installation.


How do you remove door hinges on 1988 Oldsmobile cutlass supreme?

if there are no bolts in the door jamb then they are welded in and need to be ground down and new ones welded on