No
Possibly a pressure reducing valve installed after piping for first faucet, which would cause situation describing.
No, too high of water pressure causes problems.
No, if the current faucet doesn't have a sprayer, there is no place on the faucet to attach the sprayer. It would attach on the underneath side of the faucet in the center.
Bathroom faucets are installed by pushing the faucet into the hole left by the old faucet. Before doing this, you'll probably want to apply plumber's tape or joint compound on the threads of the faucet stems and also apply caulk. Then you connect your water supply lines to the faucet stems and apply more plumber's tape to the shutoff valve threads. The last step is to tighten the coupling nuts to the faucet supply stems, taking care not to overtighten.
The faucet is clogged
well if you have a plugged aerator or your water line is corroded then that is usually the reason a faucet has low pressure if its just one faucet.
Depends on the type already installed
Turn off the pump, open a faucet and let all the pressure out of the system. Using a tire gauge, check the pressure in the bladder tank. Add or subtract air to make the tanks pressure two pounds less than the turn on pressure of the pump.
With combos of hot/cold combined. To adjust overall hot, you can do so at water htr.
No. It sounds like you have a bad pressure reducing valve if your on city water or you might have a swamped expansion tank if your on pumped water. But before you go to extreams you might want to unscrew the end of the faucet and clean the aerator.
Install a pressure reducing valve.Improved answerIf your home is on City water, then you have a PRV where it comes in the home, this can be adjusted to lower or raise pressure. To do this properly buy a pressure gauge that screws onto a garden faucet fixture. (about $10 in good plumbing stores) All you need to adjust the valve is 2 wrenches and some patience.If you are on a well this is a totally different problem. Here you need to reduce the air charge in your pressure tank, but adjust the pressure switch also. If you haven't done this before, call a well technician (NOT a plumber -they generally know nothing about well systems)
The kitchen faucet tap is threaded and is kept stationary by an upward force from the water supply. A sudden surge of pressure from somewhere else in the pipeline releases the pressure on the tap allowing the tap to move freely. While there is still a little pressure remaining on the tap it will of course take the path of least resistance and open up a little. This seems to happen more frequently as the tap threads continue to wear. Wow that answer above??? My guess is that you have a Moen faucet they are known to do this when subjected to high line pressures and the pressure fluctuates. Check your line pressure with a gauge it should be 80 psi or less or you need a pressure reducing valve installed. The faucet probably needs the cartridge replaced. == Answer== The delta two handle faucet will do the samething. And i think any washerless faucet could do it. Replace seats, spings and cartridges.