answersLogoWhite

0

You should have the flasher module in the fuse box inside the car up around the brake pedal. They both work from this. At the same time check all the fuses in the fuse box under the hood, just to make sure all are good.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What would cause the Turn signals to quit working and all other lights work hazards work also Changed turn signal switch this is for a 1988 GM sierra and Checked all fuses and flasher uit?

Blown fuse or bad flasher unit. Often, cars use different flasher for the turn signals and the flasher, so it is possible for the hazards to work and not the turn signals.


Turn signals not working but the hazzards are the fuse and flasher are ok?

replace your flasher relay


Turn signal on 1995 Mercury grand marquis not working?

Replace the flasher relay if none of them are working.


What causes the turn signals on a 1994 Ford Ranger to stop working?

if only the turn signals are not working,you should replace the flasher can


What causes turn signals to quit working?

Defective Flasher Relay.


Turn signals not working fuses are ok?

replace turn signal flasher


Where is the turn signal flasher unit on a Subaru?

Look at the related link on why turn signals are not working for where the flasher unit is located.


Why might turn signals not be working?

Check bulbs and flasher if all are out most likely flasher is bad Check bulbs and flasher if all are out most likely fuse or flasher is bad


Where is the turn signal flasher unit on a Subaru Forester?

Look at the related link on why turn signals are not working for where the flasher unit is located.


Your 97 ford explorer has no working turn signals?

replace flasher can Check fuse


Why your turn signals aren't working on your 1999 Malibu?

Check fuse,bulbs, flasher


Why have your turn signals died on your 1991 Pontiac Firebird?

Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead