0
I know its pins 7 and 18 or 19 to reset my oil light on my 325is do you know the correct pins?
Wiki User
∙ 13y ago
Switch ignition on.
Connect an LED test light between terminal 7 and earth.
After 3 seconds 5 green LEDs will illuminate.
Switch ignition off.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you reset warning tire low light on 2005 ford explorer?
As far as I know , once the tire is inflated to the correct pressure " range " and you drive the vehicle , after 1 minute the warning will reset itself
How do you reset airbag light in 1993 Geo Prism?
wish someone could answer this question looked all over the internet.nobody seems to know the correct way.if anyone knows PLEASE help
How do you reset the engine light in a 2005 Ford Thunderbird?
You are correct to a point. What you describe may on some vehicles reset the light but I answer questions to provide not only an answer but an answer that is best for a novice. An expert would not ask the question in the first place so I know this question was asked by a novice. I want the novice to not just reset the light but to have the ECU scanned to see what is wrong and have it repaired before possible damage is done to the catalytic converter or the O2 sensors.
How do you reset service light on a fiat punto?
It is important to know what the warning lights on a car means. The Service light can be reset by fixing the problem within the car, or replacing its fuse.
How do you locate and replace the EGR valve and then reset the check engine light on a 2000 Ford Mustang?
I don't know much about the EGR valve yet....but i know some autoparts stores can reset your light for free...just call around.
Is it necessary to reset a car computer after installing a part?
No, it is not necessary. But unless your reset the check engine light you will not know you replaced the defective part.
How to reset service engine light?
Disconnecting the power to the car, or computer for any length of time will not reset the check engine light, or service needed lights. The memory for these lights is stored in non-volatile memory of the computer in the car. In an OBDI or an OBDII system you must access the computer to reset these lights. As a suggestion if you have a local autoparts store they sometimes have a �Loan a Tool� program where you can rent a cheap computer access tool (This is not an endorsement, but I know Autozone rents this tool for both systems). If after resetting this light, it returns then you will need to correct the problem before it can be properly reset.
How to reset engine light?
Disconnecting the power to the car, or computer for any length of time will not reset the check engine light, or service needed lights. The memory for these lights is stored in non-volatile memory of the computer in the car. In an OBDI or an OBDII system you must access the computer to reset these lights. As a suggestion if you have a local autoparts store they sometimes have a �Loan a Tool� program where you can rent a cheap computer access tool (This is not an endorsement, but I know Autozone rents this tool for both systems). If after resetting this light, it returns then you will need to correct the problem before it can be properly reset.
How do you reset the airbag srs light on the dash of a 1995 BMW 325is?
I'm assuming you know why the airbag light came on. (you removed the seat/steering wheel/other part of the SRS) The light stays on even after the fault is corrected (ugh) and you have to use a reset tool. A dealer or service guy who has the tool, can do it in three minutes flat - but if you don't know why the light came on , they might insist on doing (and charging for) a diagnostic. Now, if you work on your car a lot and you want to buy the tool, it's a little over $100 and the tool will also tell you the fault code so you know where the problem is. The most common one to use for the BMW is the Peake R5, but there are cheaper universal ones as well. Sorry to say this isn't just one of those 'short these two wires together' solutions, but there you go.
How do you reset check engine light on 2002 Honda Accord?
You can disconnect the negative battery cable for 5 minutes which may or may not reset the check engine light. If that does not work you will need to have it reset with an OBD2 scan tool. Know that the light will just come back on if you do not repair the problem that cause the light to come on in the first place.
How can you reset the SRS warning light of the 1995 V6 Honda Accord?
if you find the answer to how to reset the check engine light on a 1995 v6 accord please let me know. Thank you. Email me at mizzle800@yahoo.com
How do you reset the maintenance light on 2005 Acura Tl 3.2 type-S?
i dont know how
