for identification a number is sprayed on the back of the sheep but the other dye goes under the male to put some on the female while they are mating...
Only if it's a draft harness for a dog cart.
on their head it's called a halter but when they pull a cart its just a harness.
The Chin Ball Harness is used within cattle. The Chin Ball Harness is put on the bulls and each bull has a different dye colour placed in their harness. It is used to give an accurate reading for what cows have been mated with which bull.
yes
i don't no!!!!!!!!!!!!!!!!!!!!!!!
Remove the transfer case shield, if equipped.Drain the transfer case of fluid.Remove the front propeller shaft.Remove the rear propeller shaft.Remove the transmission shift control cable clip from the transfer case.Remove the transmission vent hose clip from the bracket, if equipped.Disconnect the speed sensor electrical connector. Disconnect the inline to engine harness electrical connector. Remove the inline connector from the harness bracket.Disconnect the encoder motor electrical connector. Remove the clips from the transfer case brackets.Disconnect the transfer case vent hose.Support the transmission with a suitable transmission jack stand.Remove the transmission mount nuts.Remove the crossmember bolts.Remove the crossmember.Remove the transmission mount boltsRemove the transmission mount from the adapter.Support the transfer case with a suitable jack stand.Remove the transfer case adapter nuts.Remove the harness bracket. Important: The following service procedure must be performed with the assistance from another technician.Remove the transfer case, perform the following:Slide the transfer case straight back toward the rear of the vehicle.Rotate the transfer case so that the front output shaft is above the torsion bar bracket.Rotate the transfer case (with the input shaft slightly lowered) so that the transfer case is parallel to the torsion bar bracket.Lower the transfer case.
Yes it will but the front drive line will be different and the wire harness is different
All data has a diy. Site. Alldatadiy.com.
To mark which sheep is theirs, to mark which ones are going to market, to mark what sheep they may have given medication to. Farmers may also put a harness on a ram with raddle in it so they know which ewes the ram has served.
You really don't need it. You just need to identify which harness goes from the ECM to the jake brake.
The electric shift motor is located on the rear of the transfer case. Attached by 4 bolts and a wiring harness.
Some farmers put a raddle harness on the ram which has a crayon color segment so that when the ram mounts the ewe it leaves a colour mark on the ewes back
harness horse racing
The encoder motor is on the transfer case. It has a wiring harness plugged into it and is bolted to the housing. It IS repairable. GM sells the parts.
Moh's scale is a HARDNESS scale, not a HARNESS scale.
It prevents the wire making contact with other wires and shorting out. It protects the wire from erosion and allows the user to identify what each wires role is within the harness
Only if it's a draft harness for a dog cart.