An OBD1 type vehicle is not compatible with an OBD2 code scanner. You'll need to get the proper code scanner for your vehicle.
No, you need an OBD2 scanner in order to retrieve the code.
When you set up a Uniden Bearcat BC148XLT base scanner, you must program the frequencies you want to scan based on your area's frequencies. You do not need to include weather frequencies, because the BC148XLT includes weather frequencies pre-programmed in the base. You can add frequencies to your scanner in minutes, allowing you to customize the frequencies you scan.Press "Manual" to stop the scanning process. Press the number for the channel you want to program using the keypad on the scanner base. Press "Manual" after the channel number.Enter the frequency, including the decimals, using the buttons on the keypad.Press "E" to store the frequency.
You need to connect to a Comm port on a computer and use software found on the internet. It is fairly simple once you find a puter with the com port. I am not aware if a usb can be converted/used.
Visit the following address 20480 Chartwell Center Dr Suite F Cornelius, NC regarding the Bar code scanner
You have to fix the cause of the code that turned the light on. You will need a scanner to read the code.
You need a OBD2 scanner/code reader to get stored codes and to erase them
You need to connect to a Comm port on a computer and use software found on the internet. It is fairly simple once you find a puter with the com port. I am not aware if a usb can be converted/used.
You need OBD2 reader or scanner to get the codes
You have to hook up an OBD scanner to it. Most auto parts chains have one available, and can run a code diagnostic for free.
Borrow, rent or buy a diagnostic code scanner. It will tell you what you need to know. The computer turns on the light just to say that it has found a problem but you need to use the code scanner for the computer to tell you what it has found.
You'll need a code scanner that has that option built in.