The PCV valve on a 1984 Toyota Cressida is located on the valve cover, usually near the rear. It is a small component that connects to a hose leading to the intake manifold. To access it, you may need to remove any obstructions, such as the air intake duct, for easier reach. Make sure to check the valve for proper function and replace it if necessary.
On a 1987 Toyota Cressida, the starter is located on the driver's side of the engine compartment, near the bottom of the engine block. It is positioned just above the transmission and can be accessed from underneath the vehicle or from the top with some difficulty. To remove or replace it, you may need to disconnect the battery and remove a few components for better access.
mabye u need to make a gear adjustment
Where_is_the_tail_light_fuse_location_in_a_toyota_cressida_86_i_need_digram_or_schamatic_blue_print
If the check engine light is on for your 1991 Toyota Cressida, that makes that some repairs need to be made to the engine. Taking the car to a certified mechanic to perform a diagnostic test can confirm if there is any issues with the engine.
What kind of transmission fluid is used for a toyota camry 1990
yes
To get the tail light out of the 1985 Toyota Cressida wagon, you will need to access the light from the inside of the trunk. Remove all trim from around the light and across the trunk latch. Then, remove the screws that hold the light and lens in place. You can then pull the light into the trunk.
I have a 1987 Toyota 4 runner...I need to replace my manual transmission fluid....and I needto replace it with Lucas Transmission fluid....how much do I need to buy?
You will need to remove the gauges and dash . I did it at a junk yard it was lots of work . Also , you will not need unusual tools on the upside.
Yes.
According to professionals, you need to change at least 2.6 quarts of transmission fluid in a 1991 Toyota Land Cruiser. You will need a 3/8 socket wrench to remove the transmission fluid plug.