If your trying to remove the entire headlight, it's just 3 or 4 phillip screws hidden tightly between the joints of the headlight/grille/blinker.
check out this website great step by step with pictures http://www.wjjeeps.com/audio.htm
Ask him to please step out. ;-]
Ask him to please step out.
STEP 1 Raise the car & Remove both spoiler skirts. STEP 2 Remove the wing liners from the rear of the bumpers & lower the car STEP 3 Open the Hood & Remove the grille STEP 4 Move the headlamp wiper arms away from the headlamps and disconnect the washer hose Clips that hold the hose STEP 5 Remove the right and left headlamps and turn signals STEP 6 Remove the two bolts securing the bumper to the car body STEP 7 Cut the cable ties that hold fog light wiring and unplug their connectors. STEP 8 Unplug the temperature sensor connector located in the middle of the bumper. STEP 9 The sensor cable is held in place on the inside of the bumper by means of insulating tape. STEP 10 Lift the bumper away by pulling it forward so that it comes free from the brackets in wing and front. STEP 11 When replacing your bumper transfer the spoiler and number plate as well as the spoiler skirts to the new bumper
Buy a Hanes Manual for the Cherokee at auto zone, and it will tell you step by step instructions.
this website gives you step-by-step in the process http://www.installdr.com/InstallDocs/Jeep/PDF/533017.pdf you do need a "PDF" reader to use it...but it's worth the time.
Take it to your mechanic. If you are asking this question, YOU don't need to consider doing it yourself. Or buy a service manual that will give you step by step instructions.
The Next Step - 1997 was released on: USA: 13 June 1997
There are five steps on how to remove the back seat in a 1997 Chevy Malibu. Some of the step-by-step instructions are open the trunk lid, pull the top portion of the backseat all the way down, and then pull the top portion of the backseat all the way down and locate the hinges from which the seat pivots.
Step One was created in 1997.
Step to Me was created on 1997-07-27.
SEE THE LINK BELOW(Detailed step-by-step descriptions and pictures)