STEP 1 Raise the car & Remove both spoiler skirts. STEP 2 Remove the wing liners from the rear of the bumpers & lower the car STEP 3 Open the Hood & Remove the grille STEP 4 Move the headlamp wiper arms away from the headlamps and disconnect the washer hose Clips that hold the hose STEP 5 Remove the right and left headlamps and turn signals STEP 6 Remove the two bolts securing the bumper to the car body STEP 7 Cut the cable ties that hold fog light wiring and unplug their connectors. STEP 8 Unplug the temperature sensor connector located in the middle of the bumper. STEP 9 The sensor cable is held in place on the inside of the bumper by means of insulating tape. STEP 10 Lift the bumper away by pulling it forward so that it comes free from the brackets in wing and front. STEP 11 When replacing your bumper transfer the spoiler and number plate as well as the spoiler skirts to the new bumper
how much will it cost to replace rear bumper cover on 2003 93 saab
The size for a 2003 Saab front door speaker are 6.5 inches. There is room inside the door to allow for a larger speaker size.
Take the bolts out remove bummper install new reinstall bolts
Yes, to fit a towbar on a 1997 Saab convertible, you typically need to remove the rear bumper. This is necessary to access the mounting points and ensure proper installation of the towbar. After installation, the bumper is usually reattached to maintain the vehicle's aesthetic and structural integrity. Always consult the specific towbar installation instructions for your model for the best results.
STEP 1 Open the tailgate & Remove the weather-strip along the bottom edge STEP 2 Undo the two bolts retaining the load eyelets and the two plastic nuts holding the sill scuff plate STEP 3 Fold the luggage compartment carpet towards the front. STEP 4 Remove the sill scuff plate by pulling it straight up by the clips & Undo the four bumper retaining nuts STEP 5 Remove the plastic molding that holds the front edges of the bumper to the wheel housings STEP 6 Lift away the bumper by pulling it rearwards so that it comes free from the brackets
How do you replace a front indicator bulb in a Saab 93
Drain the coolant from the petcock valve on the drivers side of the radiator using a hose to direct the flow of coolant to a container such as a gallon water jug. Remove the front bumper, headlights, radiator fan. Disconnect all coolant hoses. remove the intercooler. Disconnect the oil cooler from the readiator but leave the oil lines hooked up.
Drain the coolant from the petcock valve on the drivers side of the radiator using a hose to direct the flow of coolant to a container such as a gallon water jug. Remove the front bumper, headlights, radiator fan. Disconnect all coolant hoses. remove the intercooler. Disconnect the oil cooler from the readiator but leave the oil lines hooked up.
If it is like a 1989 saab 9000, you remove the front passenger wheel, remove all the plastic from the wheel well, and the alternator should be rite there. You can also get to it by removing the manifold, which allows much easier access to the alternator, but then you need a new manifold gasket.
how do i replace the front strut on 1999 Saab 9-3
In the 2003 Saab 9-3, the throttle body is located on the intake manifold, typically positioned near the engine's front. It connects to the air intake duct and is responsible for controlling airflow into the engine. To access it, you may need to remove the air intake hose and other components that obstruct the view. Make sure to disconnect the battery before working on it for safety.
Front.