0
Yes, to fit a towbar on a 1997 Saab convertible, you typically need to remove the rear bumper. This is necessary to access the mounting points and ensure proper installation of the towbar. After installation, the bumper is usually reattached to maintain the vehicle's aesthetic and structural integrity. Always consult the specific towbar installation instructions for your model for the best results.
What else can I help you with?
How do you remove front bumper 1997 silverado?
Unscrew it.
Why would the air bags go off for no reason in a 1997 Chrysler Sebring convertible?
The air bags might deploy for no reason in a 1997 Chrysler Sebring Convertible if their is a short in the system. It is also possible that a sensor in the bumper was broken somehow.
How do you remove the bumper on a 1997 Pontiac Sunfire 4 door?
The 1997 Pontiac Sunfire front bumper is held in place by six retaining clips and for retaining bolts. Remove the retaining bolts and pry outward on each retaining clip.
How does one remove a front bumper from a 1997 Jeep Grand Cherokee?
First remove the bumper cover. You need to take off the front grill to get at the plastic retainers that hold the top of the buimber on. There are about four retainers on the bootom of the bumper.
How do you wire a towbar into a 1997 vectra estate?
http://www.volvoclub.org.uk/towbar_electrics.shtml worked for me mate and its simple good luck
How do you replace the old headlights with euro style headlights...do you need to remove the front bumper and clip?
well i had to pull my front bumper off to put the headlights on. I have a 1997 prelude so i don't know what year you have but i would guess the front bumper will have to come off.
Where is the battery on a 1997 Chrysler sebring convertible?
It is located in front of the left front wheel, inside the fender. You have to remove the wheel and fender liner to access.
How do you remove the entire convertible top with the mechanism attached from a 1997 sebring?
don t do it you need to remove the rears seats the bolt from the hydrolics rod and the bolts from the botom of the convertible make sure all the clips are of behing the bolts and make sure you take of the wirre from the class you will need some body to help you to remove the top
How do you remove the front bumper off a citreon xsara 97-00 x reg?
To remove the front bumper from a Citroën Xsara (1997-2000), start by opening the hood and removing any screws or clips securing the bumper to the top of the grille. Next, locate and remove the screws or bolts underneath the bumper, typically found near the wheel wells. Finally, gently pull the bumper away from the vehicle, ensuring to disconnect any wiring for fog lights or sensors if applicable. Be careful not to damage any clips during removal.
Location of shift solenoid b for 97 Chrysler sebring convertible?
The shift solenoid B for a 1997 Chrysler Convertible is located inside the transmission. The speed sensor has to be removed to access the bolts to remove the cover over this shift solenoid.
Where is the evap canister on a 1997 Chevy blazer?
It is located behind the left rear (drivers side) bumper extension, if you look directly in the wheel well opening to the rear you will see the heads of two bolts. The other 2 nuts are located behind the bumper, should be accessible when you remove the bumper pad, hope this helps
What was the mfsr price in 1997 for Jaguar XK8 convertible?
$70K
