0
I unplug then plugged in again my mass air flow sensor now my check engine light won't go off Can i reset it somehow 98 Maxima?
Wiki User
∙ 14y ago
Auto Zone will check engine lights and will turn off for FREE.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the cam position sensor on a 1999 Nissan maxima se?
the cam sensor is locate at the front of the engine.
Where is camshaft sensor on 2001 maxima?
The camshaft position sensor is located on the timing chain cover at the front of the engine.
1998 Nissan Maxima knock sensor removal?
See answer for same question regarding a 1995 Maxima. Think this is the same VQ engine.
Where is the IAT Sensor on the 2002 Maxima?
where is the IAT Sensor on tne 2002 maxima
What causes Engine to shut down when the map sensor is plugged in on 1992 camaro?
I would suspect the map sensor is bad.
Install crankshaft position sensor on 2004 Maxima?
where is the crankshaft position sensor on a 2004 maxima
Oxygen sensor 2001 maxima bank1 sensor 2 Where is this one?
Just locate the connector with the white cable, in the front of the Engine and it lead you to the oxygen sensor. It has to be attached to the Pre- Cat
Could a crank shaft sensor cause my 2005 Nissan Maxima to go into limp mode?
A bad crankshaft sensor would stop the engine and not restart.
Where is the coolant temperature sensor located on a 1995 Honda Civic EX?
Follow the lower radiator hose from the radiator to the back of the engine. Where it connects to the engine, you will see wires plugged in to the sensor
Where is the camshaft sensor position a located on a 96 maxima 3.0?
where is the camshaft sensor in a 96 nissan maxima 3.0
1995 nissan maxima knock sensor location?
I really depends on the engine. On the 4 cylinder 2.4 ltr engine, it is on the block near the oil filter.
Does the decat pipe need to have the oxygen sensor fitted for a Subaru Impreza?
im also need the answer , i got a decat pipe on mine and my sensor is still screwed into it and plugged in but if your decat hasn't got the threded hole for the sensor then i would either drill it and tap and die it or keep it plugged in but tie it up out of the way but if the car starts playing up then you will have to fit it somehow.
