0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is port and harbor engineering?
a word port can used for any place where goods and passenger are transfered from waterborn mode to landborn mode .
What is the true bidirectional port in 8051 microcontroller?
Port 0 is called true bidirectional port.............. swapneel
When using a Digital multimeter the black lead usually goes into which port?
On a digital multi-meter the black lead connects to the common (COM) port in the meter.
How can the port life of adhesive be extended?
How can port half of adhesive be extended
Which port should you connect a router to a lan?
It shouldn't matter which port you use unless it involves a network switch.
What step must be completed before port security can be enabled on an interface?
The violation mode must be configured.
What switch port modes will allow a switch to successfully form a trunking link if the neighboring switch port is in dynamic desirable mode?
since the first desire of desirable mode is to trunk,so the switch port mode will be trunking since the first desire of desirable mode is to trunk,so the switch port mode will be trunking
What is bsr mode?
this mode is related to only port c.the bits of port c can be controlled directly by the microcontroller
What is port and harbor engineering?
a word port can used for any place where goods and passenger are transfered from waterborn mode to landborn mode .
When might you need to disable ECP mode for parallel port?
An occasion when you need to disable the ECP mode for parallel port is when resource conflicts occur. In such a case, the EPP mode is the better option.
What types of information are included in the show cdp neighbor command?
Device identifiers, A port identifier and Platform information.
When port security is enabled a switch port uses the default violation mode of until specifically configured to use a different violation mode?
Yes, By default port security is disabled on a Cisco switch. If it is enabled the default violation mode is shutdown with a maximum MAC address count of 1. Even if port-security is enabled it will not place a port into the shutdown state until either MAC address sticky or a static MAC address is configured on the port.
When might you need to disable ECP mode for a parallel port?
# If you are having problems with resource conflicts, you could try disabling ECP mode for the parallel port. EPP mode gives good results and does not tie up a DMA channel.
When port security is used on a switch which violation mode will cause an snmp trap to be sent and traffic to be dropped when the number of secure MAC address for a port is reached?
Port security is used on a switch and the number of secure MAC addresses for a port is reached, the violation mode that will typically cause an SNMP trap to be sent and traffic to be dropped is the "Shutdown" or "Protect" violation mode.
What is the best mode of transportation from city center in Rome to the port?
the answer is Detroit
What is the purpose of issuing the command switch-port mode access on a switch interface?
force the port to be a part of a single vlan
What is switchport mode configuration?
Switchport mode allows for the configuration of a port into certain settings. A few examples are Access, Trunk, and Dynamic. Each mode allows for different functions. Access mode is used for end devices, this allows for certain port security settings. Trunk mode is used for lines between switches and other lines that send multiple VLANs over a single connection. Dynamic will automatically detect what kind of device is connected and initiate its port accordingly.
