0
What else can I help you with?
Where is the afm sensor on 1990 Chevy S-10?
how do you install a 1994 Chevy prism ignition
How do you install oxygen sensor for Chevy Metro?
you gotta take the old one out first
How do you change the oxygen flow sensor on a Chevy Malibu?
Very simple. Unplug the wire to the sensor, unscrew/remove the sensor, install new sensor and plug it in. You're done. Have fun.
How do you install abs speed sensor on 97 Chevy suburban?
first step you must removed the tire then the brakes then the four 15mm bolts head then you can access the abs sensor then reversed to install it
Where exactly is the 2000 Chevy Impala crank shaft sensor?
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
How do you install a camshaft position sensor on a 2001 Chevy impala?
Are there any videos that show the replacement on replacing camshaft sensor on 2001 chevy impala3.4. Cant find any on youtube, thanks
How do you install a temp sensor on a 350 Chevy motor?
Most of them are as simple and unbolting the old one and bolting in the new one.
How do you install a throttle positioning sensor on a 1999 Chevy Tahoe?
you may have to install the sensor positioned up and down and then rotate the sensor clockwise to align the bolt holes. The insides of the engine part are spring loaded and sometimes the sensor needs to be position on flat then rotated some way to line up the holes.
Install new knock sensor for a Chevy silverodo 1500?
The 1500 Chevy Silverado has two knock sensors. There is one on each side of the block halfway between front and back.
How do you change a knock sensor on 1991 Chevy 350?
Make SURE the engine is COLD. Then unscrew the old sensor and install the new one. Antifreeze will leak out of the engine so be quit when replacing it.
Where is the map sensor 1997 Chevy?
Where is the map sensor on a 1997 Chevy 1500?
How do you install crank sensor 2000 Chevy prism?
To install the crankshaft position sensor on a 2000 Chevy Prism, first, ensure the engine is cool and disconnect the negative battery cable. Locate the crank sensor, which is typically found near the bottom of the engine block, and remove the mounting bolt. Disconnect the electrical connector and replace the old sensor with the new one, securing it with the bolt and reconnecting the electrical connector. Finally, reconnect the battery and check for proper operation.
