it is dented more than 1/4 inch
the threads are damnaged
it is dented on the seam
it is dented on a seam it is dented deeper than 1/4 inch the threads are damaged
it is dented on a seam the threads are damaged it is dented deeper than 1/4 inch
It is dented deeper than 1/4 inchIt is dented on a seamThe threads are damaged
when should the vapor canister be replace on a 1996 pontiac sunfire
The threads are damaged. It is dented deeper than 1/4 inch. It is dented on a seam.
It is dented on a seam. It is dented deeper than 1/4 inch. The threads are damaged.
It is dented deeper than 1/4 inch. The threads are damaged. It is dented on a seam.
The fuel filter will pull out of the canister when removed.
It can cost as much as about $300 to replace the charcoal canister on the 2002 Hyundai. This varies according the mechanic labor pricing in your area. The canister averages around $100 to $150.
To replace the vapor canister on a 2001 GMC Sonoma, first, disconnect the negative battery terminal to ensure safety. Then, locate the vapor canister, which is typically found near the fuel tank or under the vehicle. Remove any mounting bolts or clips securing the canister, disconnect the hoses and electrical connectors, and replace it with the new canister. Finally, reattach the hoses, connectors, and bolts, and reconnect the battery terminal.
To replace the vapor canister on a 2003 Kia Optima, first, ensure the vehicle is off and safely elevated. Locate the canister, typically found near the fuel tank or under the vehicle. Disconnect the electrical connector and the hoses attached to the canister, then remove the mounting bolts. Install the new canister by reversing the removal process, ensuring all connections are secure before lowering the vehicle.
My canister was in the Left Rear fender well. Right behind the taillight. You must jack the car up, remove the LR wheel, then using your 4 foot long left arm, feel behind the tail light. Most often the hoses are dry and loose fitting. Replace them if you can. You should also replace the valve on top of the canister because once you replace the canister, you will probably never visit this area of your car again. There is a bolt that holds the canister to the inside of the fender well. You should unplug the electrical connector on the valve on top of the canister, then disconnect the hoses that connect to the top of the canister. Once you have removed all these, you can remove the bolt holding the canister, and bring the canister out into the sunlight. Replace all the hoses if you can, then install your new $85.00 canister back in place and connect the hoses and electrical plug. Because of its location, this can be a very frustrating job. You need the hands of a child, on 4 foot arms, and double joints. Paul