This answer should contain the amount of turns that the primary and secoundary have.
Efficiency of the device. How much work is applied to an object to make it move vs how much energy the object recieves.
The applied force to the end of the handle is the input force and the output force is when the broom sweeps over the floor.
The input of a load cell is the force or weight applied to it. The output of a load cell is an electrical signal, typically in the form of voltage or current, that is proportional to the applied force or weight.
force output x distance = work output ~same for input
Power supply: Water pump, producing pressure at its output valve.Resistor: A section of pipe. Flow of water loses energy on the way through, due to friction with the pipe's interior wall.Potential difference: Difference in water pressure between the beginning and end of the pipe section.
Actual output is the "real" GDP ( gross domestic product). potential output is the targeted output set by the government. the difference between the actual and potential output is UNDEREMPLOYMENT!
The 'input' side of a transformer is called its 'primary' side, whereas the 'output' side is termed its 'secondary' side. The ratio of its secondary to primary voltage is equal to the ratio of the number of turns in the secondary windings to the number of turns in the primary winding. So if, for example, a transformer's secondary winding has twice as many turns as its primary winding, then the secondary winding will produce twice the voltage applied to the primary winding.
There would be no rectified output. The transformer primary has to be closed to induce a current into the secondary winding. At this point of the secondary the voltage is still AC. This voltage is then applied to the rectification bridge to change it to DC. So you can see how no voltage on the primary, the same as the unit being unplugged, affects the output voltage.
According to the theories of macroeconomics, if actual output exceeds potential output, then the output will continue to grow as the price of inputs continues to fall.
pH is a potential, with no unit, it has no input and no output.
Potential output is the capacity to produce should all factors be employed in an economy. For example, it is the output should there be no unemployment, no spare labour and no spare capital. It is unlikely that actual output will be the same as potential ouput since there is always unemployment.
This is known as the recessionary gap
expansionary output gap has occured.
A; An integrator will integrate or slowly change as a rapid input is applied. Differentiate will have just the opposite effect
The difference is in the output frequency.
potential
inflation rates tend to accelerate