0
If a 1996 Ford Windstar ECT gauge stays below cold all the time and the sensor works fine but circuit continuity test fails should the temperature gauge or circuit wire be replaced or what is wrong?
Wiki User
∙ 17y ago
More than Likely its a coroded connector at the sensor.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What describes continuity in a circuit?
Continuity in a circuit means no breaks; continuous.
What best describes continuity in a circuit?
Continuity in a circuit means no breaks; continuous.
Circuit continuity is measured using?
Circuit continuity can be tested by using an ohm meter.
What is continuity test?
a continuity test is the checking of an electric circuit to see if current flows. That it is in fact a complete circuit.
What is a continuity test?
a continuity test is the checking of an electric circuit to see if current flows. That it is in fact a complete circuit.
What is the difference between continuity and resistance check?
Continuity is checking for a completed circuit including a short circuit. Checking resistance would be checking in ohms resistance of a circuit, motor windings or an open circuit.
Where do you put your leads when checking continuity on a series circuit?
When checking continuity in a series circuit, you put your leads in series with the circuit or device being checked. You also make sure the circuit is deenergized and that it is open.
What does it mean when you get a code p0713 on a 2000 ford windstar sel?
Trouble code P0713 means:Transmission fluid temperature sensor circuit high input
What parts to circuits have to contain?
The absolute minimum for a circuit is continuity. Without this it is not yet a circuit.
What is electrical continuity?
Electrical continuity denotes that the current from the source is successfully reaches the negative terminal. If there is no continuity means, the current will not flow through the circuit.
What test don't you have to do on a lighting circuit?
A continuity test, just turn the lights on and if there is continuity the fixtures will let you know.
When resistance and continuity test are made on electronic circuit components the circuit being tested should be?
Open
