0
If a miner is standing on a fault the wall is where his safety helmet would be and the wall is where his steel toed boots would be.?
Wiki User
∙ 7y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Who is at fault when you crashed in to a door of a parked car?
If YOU hit something that was standing still, it can only be YOUR fault .
Carrier free standing fault error?
error7
What is abs light standing for in a Honda?
It means you have a fault on your Anti-lock Braking System
What are the specific safety precautions that need to taken when carrying out fault diagnosis of the specific piece of equipment?
Describe the specific safety precautions to be taken when carrying out fault diagnosis of the specific piece of equipment
Who is at fault when you are backing out and a car pulls up behind you after you have looked?
it is ALWAYS the fault of the backing driver. They bear the responsibility to make sure they can back with safety.
What are the safety percussions before during and after tsunami?
dont panic and say your life if you fail its not my fault
What is a breaker and what is it used for?
An electrical breaker is a safety device used to open a circuit that has an electrical fault on it.
What is furnace ignition fault?
some problem with your furnace that caused a safety switch to trip on the inside of your machine. Usually on units it will have leds indicating what safety the machine tripped on.
Are standing waves are produced in electrical transmission system?
If the electrical transmission system is properly designed and installed, then there are no standing waves. If they do exist on the electric line, they are a fault that must be cured. They don't belong there.
When someone is injured in a job its usually not anyones fault?
When someone is injured on the job, some are accidents and not anyone's fault. Injuries can result from falling, being struck by an object, or from climbing, bending, standing, or reaching.
How can you complain about Ozark Trails Boots?
The assumption is that if it's manufacturer fault - you'd get in touch with the shop you bought them from, or at a push, the company that made them (Ozark?).If they're not manufacturer fault, I.E. A poker hole in the sole, you've only yourself to blame.
Is a ground wire necessary for a complete circuit?
No, the ground wire is there for safety reasons and only carries current in fault conditions.
