Preferably to the IDE0 which most of the time is the Blue connector.
The blue connector is primary, black is secondary
Blue
HDMI is currently the only single-connection cable that combines both Audio and Video.
A blade connector is a type of single-wire connection using a flat blade which is inserted into a blade receptacle.
Reserve pin fool proves the connection by allowing the connection only in a single way.
It should be self-evident. It's a motherboard capable of supporting a single CPU.
If you have single phase now, you have two options. One, is to install a three phase service or Two, install a roto phase device.
A regular ATX motherboard uses a single 20-pin P1 connector with optional 4-pin auxillary power connector
The AT form factor measures 12" x 13.8" compared to the smaller ATX at 12" x 9.6". The power supplies for AT systems supply +5, -5, +12, and -12 volts to the motherboard and other components, and uses two power connections, the P8 connector and the P9 connector. The power supplies for ATX systems supply the same voltages plus a +3.3 volt circuit for alow-voltage CPU, and use a single power connector called a P1 connector. AT motherboards, which are no longer produced, were difficult to install, service, and upgrade and with the AT form factor the CPU was placed on the motherboard in front of the expansion slots resulting in long cards not fitting because they bump into the CPU. On an ATX motherboard, the CPU and the memory slots are rotated 90 degrees from the position on the AT motherboard, so instead of sitting in front of the expansion slots, the CPU and memory slots sit beside them allowing the use of full length expansion cards.
you will need an internet connection to activate the disc and install some software but after that you can play without it
I think you're talking about a grounding connector that allows multiple connections to be made to it, thus looking like a 'Star' when viewed from above. This would be opposed to a single-connection 'jack' where only one connection is made to the 'jack', or lug.
P1 connector
It is more expensive than a single CPU socket motherboard
The fan will have a pair of short wires that come out of the fan motor connected to another short pair of wires going back to the fan's motor. The 2 pairs will be connected to each other with either a single 2-prong connector or two single-prong connectors. Reverse the connection pairings and the fan will spin the opposite direction. (If you have a 2-prong connector, just unplug the connector; twist one end of the connector 180-degrees; then reconnect.)