No it's series circuit.
Do nothing. But in a parallel circuit, all the bulbs will get dimmer.
um.. a switch is a part of a series circuit because parallel circuits don't have switches
The lamps will get dimmer. In a parallel circuit, voltage is constant. Whereas, in a series circuit, amps are constant.
If a component of a parallel circuit fails, there are complete pathways for electricity to allow the remaining components to carry on functioning. ( For instance if the living room light bulb fails, the kitchen light can still work.) Also, if you link several bulbs in series, the current through them drops and they are dimmer than one on its own, but this doesn't happen with a parallel circuit.
Bulbs in a parallel circuit draw the same amount of current, so each will display the same brightness. Bulbs in a series circuit share the current so all bulbs will appear dimmer.
Parallel circuit lights are built as so: ______light_______ |_____light_______| |_____battery_____| Series circuit lights are built like this: ___light___light___battery___ |________________________| In a parallel circuit, lights don't get dimmer when you add more, and if one breaks, the others still work. In a series circuit, when you add more, the lights get dimmer, and when one breaks, they all break. It is possible to have a combination of both in one circuit though.
Because some of it was absorbed so then it Becomes dimmer
something in a circuit
this depends on 1. whether the extra bulbs are being connected in parallel circuit or in series with each other, and 2. the power rating of the battery. supposing the battery power rating is greater than all the individual bulbs put together, the bulbs will glow the same maximum intensity if they are connected in parallel, and will become dimmer if connected end to end i.e in series.
Everything in the series circuit will run dimmer / slower / cooler.Since the available voltage is constant (13.6 volts from the battery), increasing the resistancein the circuit causes the current through each device to decrease.
Voltage. A dimmer usaly chops the sine wave, leting it pass after a while.Another answerThe dimmer effectively becomes another device in the circuit. It effectively becomes a series circuit, therefore the voltage to the dimmed lights will be reduced in proportion with the relative position of the dimmer switch. HOWEVER...there is such a thing as "pulse width modulation" dimmers. They are typically used for devices that need full voltage but but you need to reduce output... such as fluorescent lights some fans and many other motors.Most dimmers are resistance type dimmers since the pulse width modulation dimmers are far more expensive.
They don't unless you speaking about a parallel circuit in which total currect would be the sum of all the currents in each light bulb (The more light bulbs, the more current draw) If you're talking about a series circuit, nothing at all happens to the current, as in a seires circuit current is constant throughout the entire circuit (voltage changes). In a case such as this the more light bulbs in the circuit, the less the voltage becomes across those bulbs (furthest from the source), thus they will become dimmer due to lower power (P=IE).