Before removing the distributor, set the engine at TDC and mark the relevent position of the distributor with the engine. When re-installing, ensure it goes back in with the marks lining up, and snug the hold-down bolt just enough where the distributor can still be rotated by hand. Connect all wires exactly as they were prior to removal. If you are going to use a timing light, mark the correct degree line and the TDC line with white chalk or similar. Start the engine and perform timing either with timing gun or by ear. After timing is completed, tighten the distributor hold-down bolt.
Cut it and pull it off. Be sure to take a look at the installation of the belt before removing it. You will need to install the new in the same configuration. Tightening the belt can be tricky.
Brake pads on a 1997 Toyota Celica are changed by removing the wheels, unbolting the calipers, and removing the old pads from the calipers. The caliper piston must be pushed in before the new pads can be installed.
First and foremost, make sure you have a diagram before removing the old belt. If there isn
I removed the distributor in my 96 gmc yukon but I forgot to mark it before removing it.What do I need to do to get it back in.
sounds like you have moisture in the distributer next time it wont start, remove distributer cap, and using a hair dryer, dry inside distributer cap,and inside distributer
A radiator is held on the mounting brackets. Before removing the radiator on a Toyota Starlet it will need its coolant drained. Remove all the mounting bolts and disconnect the hoses to pull the radiator off.
I've never seen a globe in a Toyota Avalon ac switch. But a new globe can be bought in a map store. Before you install it, be sure you have NORTH on the top.
remove distribtrer cap,remove distributer.un plug from pick up coil.remove two bolts holding module..must use dielectric lube supplied with new module...coat entire metal surface before installing new module..distributer must be at top dead center when installing distributer unless you marked posision of rotor prior to removing....
Removing a plastic cover on the pillar beside the passenger's seat (beneath the seatbelt exit point) reveals the radiator cap. Ensure the engine is cold before removing. Take care when filling, because water can spill into the cab.
ALWAYS check the gap before you install plugs
Your timing is to far before top dead center you need to advance it turn the distributer foreward.
No. It installs itself, removing 2.0.0.7 in the process. Well, 2.0.0.8 hasn't been released yet, so, yeah, as with all Firefox versions, it will just update the program to that release, by adding stuff to it, not removing anything.