answersLogoWhite
Clutches and Flywheels

If the clutch is constantly slipping in a 1986 Mazda 626 DX where and how do you add clutch fluid?

676869

Top Answer
User Avatar
Wiki User
2006-05-22 19:39:13
2006-05-22 19:39:13

you dont add clutch fluid. If the clutch is slipping that means that you need to buy a new clutch

1

Related Questions

User Avatar

where do you add clutch fluid on a Mazda 1997

User Avatar

1. Clutch fluid is brake fluid. 2. The fluid used for your clutch master/slave cylinders is pulled from your brake fluid reservoir.

User Avatar

You don't use clutch fluid for a manual transmission vehicle.

User Avatar

No, slipping is not affected by low hydraulic fluid level. The hydraulics of your clutch only DISENGAGE your clutch, they do not engage it. If it's slipping, it's either worn out, the pressure plate springs have weakened or you have oil on the clutch disk.

User Avatar

next to the brake fluid reservior

User Avatar

it uses the "extra" fluid from the brake reservoir, so just check that you are ok on brake fluid and your clutch should be fine

User Avatar

The clutch hydraulic fluid reservoir for a Mazda 121 is located next to the brake booster and brake master cylinder. The reservoir is small and round and is close to the driver side fender.

User Avatar

On the firewall drivers side. Clutch runs from the brake reservoir

User Avatar

We have just had some probems with our Mazda E2000 Campervan, and needed to fill the clutch fluid. While we had some difficulty finding the reservoir, there is a reservoir near the steering wheel on the left. It says that it is for brake fluid, but it is also for the clutch. We bled the clutch and while bleeding it the reservoir where the brake fluid is store dropped confirming that this is also the clutch reservoir. Hope this helps.

User Avatar

adjust it correctly, use stock primary fluid and make sure the fluid level is correct.

User Avatar

Assuming you have an automatic, suspect low trans fluid level. If it is a standard, the clutch is slipping.

User Avatar

Type f ATF is highly friction modified to allow more clutch slipping, and converter slipping, than regular ATF. You can use newer fluid in older tran but you can not use older fluid in a new trans.

User Avatar

Refer its wners manual or Simply, take it to the mechanic.

User Avatar

Isnt one, its hydraulic, and its next to the brake fluid resevior

User Avatar

If it's a 1970cc Station Wagon it's next to the brake fluid reservoir on the bulkhead. The rectangular one is the brakes, the cylinrical one is clutch.

User Avatar

mazda mechanic says no,at least with my problem.possible,it could be air in fluid?check small fluid reserve on drivers side,by fuse box.it does say to use brake fluid in this reserve.

User Avatar

usually a clutch does not seize. what happens is that your clutch is not moving, it could be from: no fluid in line, broken fork, air in the line, damaged pressure plate. but if for some reason the clutch is seized... then you will have to replaced clutch and flywheel.

User Avatar

its in the engine bay next to your brake master cylinder its the tube like cylinder that says dot3 fluid

User Avatar

The VW Beetle does not have clutch fluid. There is not any fluid associated with the clutch. The transmission has transmission fluid.

User Avatar

You dont..its hydrolic...if the petal spongy..check the fluid level in master..at drive side firewall..if low add..brake fluid...get new master..and or slave... If its slipping...time for a clutch assy....

User Avatar

my car has been slipping in the transmission would it be the that the transmission is bad or is the filiter and the transmission fluid needing changed?


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.