yea that's not good ur better off putting in more then putting in less in ur case its a lot less
if it has a clutch, the clutch needs replaced. if it's an automatic, it needs to be overhauled by a dealership or competent transmission shop.
Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced. Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced.
Clutch needs adjustment/replacement Synchonizers worn?
It means the reverse clutch pack has gone out in your transmission and needs to be rebuilt or replaced.
it does'nt..dodge made the cars with a cable clutch or is the transmission low on fluid? use 5w30 motor oil ........ only use transmission fluid if its automatic
The pressure plate is what the clutch presses against to drive the transmission. The plate is a metal round disk that needs to be smooth for a good connection to the clutch.
The 1993 Saturn used a self adjusting hydraulic clutch system on the manual transmission vehicles. As such, the clutch never needs adjustment. If you're having trouble with the clutch, it is most likely because of a worn or damaged clutch assembly.
You might want to maybe change or refill you transmission fluid in your vehicle. Also, you might have been "riding your clutch" in this case it needs to be changed.
well if you put the car in any gear and let out the clutch if you rev the engine and it dosent move or moves a little then it's the clutch but if it's a grinding noise and it doesnt move at all i'd say its the transmission my car was grinding and not moving and it was cause the spider gears were all busted and i had to rebuild my transmission
It depends on the transmission type. For a 4-speed automatic transmission (4F27E) needs a torque converter, but for a 6-speed PowerShift needs no torque converter at all, it using the Dual Clutch technology.
If its an AUTOMATIC transmission,,,,More than likely,,,its the bands and clutches needs replacing in the tranny,,,if its a STANDARD,,,,its the CLUTCH,,,PRESSURE PLATE needs replacing Semper-Fi Devil-Dog
Depending on your problem it may be a serviceable part, however if your issue has anything to do with you clutch plate or fly wheel then no- it is not adjustable. Most of the major components of your clutch (fly wheel, clutch plate, throwout bearing are serviced when clutch is or needs to be replaced because in order to access these parts you must remove the transmission.