answersLogoWhite

0

Yes it would as the acceleration is always be towards the centre and the acceleration would be directly proportional to the negative of the deplacement of the object.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What happens when a ball is dropped through an imaginary hole through the earth?

If the hole passed through the DIRECT center of the earth, it will stop when it reaches the DIRECT center of the earth, it will do this because the are equal amounts of gravity forcing being applied on each one of the infinite sides of the circle.


How do you remove the harmonic balancer on a 1996 dodge neon?

loosen the center bolt and get your self a harmonic balancer puller just make sure you loosen the center bolt enough but not too much but you need a balancer puller.


Technician A says the harmonic balancer may be attached to the crankshaft using a Woodruff key and center bolt. Technician B says the harmonic balancer may be attached to the crankshaft using a square?

The harmonic balancer is attached to the crankshaft using a Woodruff key or a square key and center bolt.


Where is the harmonic balancer on a 1998 Lincoln continental?

the harmonic balancer is the crankshaft pulley approx6 or 7 inch diameter lower pully center of engine the serp belt is driven by power pulley also have a retaining bolt in center


Where was hiroshima dropped?

North of the center of the Citi


How do you remove the harmonic balancer in a Nissan Maxima?

To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.


How do you get to Taro on AQW?

TaroRight, Left, Center, Right.Aracara Fang - Dropped by AracaraEscherion's Chain - Dropped by EscherionStrand of Vath's Hair - Dropped by Vath30x Defeted Makai


Does atonal harmony establish a harmonic center of gravity?

if this question is for music appreciation class the answer is on p.361


If you drilled a hole straight through the earth and dropped a bowling ball down the hole would the ball come to rest at the center?

The ball will NOT come to rest. It will oscillate around the center of the earth in simple harmonic motion. Incorrect. the ball will rapidly reach a terminal velocity ( maximum speed given the resistance of the air). as the ball gets closer to the center of the earth it will slow down as the force pulling the ball towards the earth it has already passed through becomes closer to the force of the earth the ball has not yet passed. Upon reaching the center of the earth. the bal will minimal , and for a short time, oscillate until rapidly coming to rest at the center of gravity.


Were is the crank sensor on a Pontiac grand pri?

The crankshaft position sensor is located behind the harmonic balancer. You will need a harmonic balancer puller and an impact wrench good for at least 750 ft pounds. Access the harmonic balancer through the passenger side wheel well. Remove the harmonic balancer center bolt and use the puller to remove the balancer. Use 1/4 - 28 X 3 inch bolts on the puller. The sensor is held with two screws. Be careful not to damage the weatherpack connector when releasing it from the sensor.


What would happen to an object dropped into a hole that went through a planet's center and out the other side?

The gravitational pull of the planet would prohibit the object from leaving the center of the planet, and since most planets have magma in their center, the object, depending on what it was made of would probably burn up.


How do you replace the harmonic balancer on a Chevy small block?

There is a bolt in the center of it, 5/8ths inch. Remove that, then the three 9/16ths bolts in a triangle pattern, which removes the pulley. Then, you will need a harmonic balancer puller, as they are pressed on.