Dig a small hole and take the cutting edge of a knife and give your
connection to it and close the hole and pour some water.
=== === === ===
copper has no linear portion to their stress-strain curve, so the offset method cannot be used. The European Standard for general-purpose copper rod, EN 12163 (Ref 8), gives approximate 0.2% proof strength.
Generally a larger diameter copper wire would create the least resistance to electron flow. Copper is the most conductive and is widely used.
If you are referring to the use of aluminium windings, instead of copper windings, then the answer is yes. However, because aluminium has a higher resistivity than copper, to produce the same rating as a copper-wound machine, the aluminium conductor would require a slightly larger cross-sectional area, which means that that the machine would be somewhat larger.
When compared by volume, copper is best, then aluminum and finally iron. When compared by weight, aluminum is better than copper. You have to compare by volume because aluminum is so much lighter than copper, an aluminum wire that weighed the same as a copper wire would be much bigger and harder to work with.
If a bar of copper is brought near a magnet and rubbed it will get magnetized and would behave like magnet. But this would be temporary and this property would wear after some days.
If I were facing this issue, I would run a new copper wire for the range circuit. Call an electrician, who can provide you with options.
most likely a bad wire or a lose connection on the back of the outlet!
Copper is considered a non-renewable resource because there is only a limited supply of it on Earth, like any other thing would be. Once it runs out, it is gone for good.
No, copper pipes need to either be soldered, or connected with compression fittings. PVC cement will not bond with copper and provide a "solvent weld", it would be a very weak connection.
That would be ITU G.992.5 also referred to as ADSL2+ or ADSL2Plus.
If a Google Earth server is not available for connection (due to network problem etc.) and you have flushed your cache, the screen will be black.
One comes across this problem while selecting connectors in equipement terminal made of cu and connector is made of Al. One is not sure if one needs to use some bimeatalic plate in this case and why its not recommended to connect Cu with Al in this case. What would be the impacts?? The success of a copper to aluminum connection depends upon the amount of current involved, but copper to copper is a better connection than copper to aluminum. Copper is a good conductor of electric current and so is aluminum but the resistivity of the two metals differ and could result in differential heating to distort the metal connectors in high ampere or voltage.Other than this there will be no difference if one connects copper to aluminum.
Only if the acid is above the melting point of copper. However, the copper might dissolve in acid if the acid is oxidizing. If it did, copper ions would be present in the solution formed, but there would not be an metallic copper in it.
Aliens have a great chance of being real, just not close to Earth. Aliens have a great chance of being real, just not close to Earth. we would get better xbox 360s and better connection
I would assume copper
there would be a single replacement reaction where the copper forms on the top of the zinc and the blue color of the copper sulfate would get lighter and eventually you would end up with zinc sulfate and copper