0
What else can I help you with?
What resistor is needed for a 6v dc motor with a 4.5v battery?
A 6v motor might not run at all on a 4.5v battery. Whether or not it does, it's likely to discharge the battery rather rapidly. A series resistor will help the battery last longer, but will make it even less likely that the motor will run at all. You're better off taking some time to find either a 4.5v motor or a 6v battery.
Can you charge an 8 volt battery with a 12 volt charger?
No, it would overcharge and ruin the battery. #2 You can do it by using a series resistor to limit the current. The resistance needed is equal to the voltage drop divided by the charging current. The voltage drop is 4, and the charging current is one tenth the battery capacity, for example for a 2000 mAh battery the charging current is 200 mA. So the resistance needed is 4/0.2 or 20 ohms. The power dissipated in the resistor is 4 x 0.2, or 0.8 watts, so you need a 20 ohm 1-watt resistor. The battery should be charged for at least 10 hours if fully discharged, or until it becomes slightly warm to the touch. Do NOT let it overheat.
Materials needed to make a resistor.?
carbon
How do you get to the heater resistor on a 1998 Pontiac transport?
To access the heater resistor on a 1998 Pontiac Transport, first, disconnect the negative battery cable to ensure safety. Then, remove the lower dashboard panel beneath the glove compartment to gain access to the heater assembly. The heater resistor is typically located near the blower motor; unscrew it from its mounting and disconnect the electrical connector to replace it as needed. Reassemble the panels and reconnect the battery once the replacement is complete.
What is a satellite receiver?
A satellite TV receiver is needed in order to view satellite programming. Additionally, a satellite dish is needed in order for the receiver to decode digital signals which then allows you to watch TV.
When is the resistor bypass used in the ignition circuit?
The resistor bypass in the ignition circuit is used when starting the engine. It bypasses the resistor to provide full battery voltage to the ignition coil, ensuring a strong spark for a quick and reliable engine start. Once the engine is running, the bypass is no longer needed and the resistor is re-engaged to limit the voltage to the ignition coil for normal operation.
When The giver Explained why the people needed a receiver of Memory what were the reasons?
The Giver explained that the community needed a Receiver of Memory because memories of the past help make important decisions, provide wisdom, and serve as a guide for the future. Without a Receiver, the community would lack understanding of their history and the capacity to learn from mistakes.
What battery is needed for 139.53681B?
2032 3V Lithium Battery
What resistor is need pull 1500Ma?
To calculate the resistor needed to pull 1500 mA (1.5 A), you need to know the voltage across the resistor. Using Ohm's Law (V = I × R), you can rearrange it to find R (Resistance = Voltage / Current). For example, if the voltage is 5V, the resistor needed would be R = 5V / 1.5A = 3.33 ohms. However, ensure the resistor can handle the power dissipation, calculated as P = I² × R, which in this case would be approximately 7.5 watts.
What does fuel pump resistor do?
A fuel pump resistor runs the fuel pump at a lower speed when the demand for fuel is lower. When more fuel is needed the system bypasses the resistor and allows the fuel pump to run at full speed.
Is a receiver needed for tomtom traffic?
Yes but, there are different receivers for different modles.
What tools are needed to replace 1995 riviera supercharged battery?
The supercharger has no battery.
