1995-2005 Chevy Cavaliers

If you have a 2001 Chevy Cavalier with an engine from a 2004 which O2 sensor should you buy 2001 or 2004?

272829

Top Answer
User Avatar
Wiki User
2006-05-18 20:15:21
2006-05-18 20:15:21

that depends which wiring do you have the 01 or the 04 if 01 then get the 01 if not get the other

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Do you have a picture of location of crankshaft position sensor for 1992 Chevy Cavalier 2.2L ohv engine?

User Avatar

The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.

User Avatar

How do you unplug an oxygen sensor on a 2003 Chevy Cavalier

User Avatar

how do you change a thermostat sensor in a 2001 Chevy cavalier and where is it

User Avatar

As long as it is the same displacement. Liters/cid. It should

User Avatar

could be the oxygen sensor. that's what it was on mine.

User Avatar

its located at the rear of the engine (center) attached to the block

User Avatar

Where is radiator temperature sensor located on a 1997 2.4L Chevy cavalier

User Avatar

There are 2...On the exhaust manifold and after the cat. converter

User Avatar

Why are ets and engine light on in 98 Chevy cavalier

User Avatar

there is two of them, ones on the top and there is one on the bottom of the engine.Here is how you would change them.http://www.ehow.com/how_5059297_change-oxygen-sensor-chevy-cavalier.html

User Avatar

You can swap the engine from your 1997 Cavalier 2.2 liter engine to your 2000 Chevy Cavalier. The wiring harness and motor mounts should be in exactly the same.

User Avatar

if it is the same size engine all parts should fit.cavaliers from 1995 through 2004 are the same

User Avatar

Well yes and no. Both have a 2.2 four cylinder if I'm not mistaken, but I don't think the earlier Cavalier's have the EcoTec motor. And you should be able to get the engine from the '03 into the '97 with no problem.

User Avatar

The themostat is located in the top rad hose on the engine side, but I don't know about the sensor. In my 91 the coolant temp sensor is in the thermostat housing and the engine temp sensor is on the block.

User Avatar

Back side of the engine near where the transmission mounts to the engine. You have to jack up the car and crawl under it to see it. There are two sensors there.....the crankshaft sensor and the knock sensor.

User Avatar

Facing the engine, it's on the top left. It can be seen without moving anything.

User Avatar

It is located on the back side of the engine, where the distributor originally went.

User Avatar

Right in the front, on top the engine,in the intake cam tower.

User Avatar

Connected to the upper radiator hose. Coolant flows from the engine to the radiator to be cooled. The coolant temp. sensor should be screwed into it.

User Avatar

i don't see why not the 2.2 was used in 95 and 96 should fit right in

User Avatar

A B1S1 O2 sensor would be threaded into the exhaust system between the catalytic converter and the engine.

User Avatar

The 98 Cavalier 2.4 is a NON interference engine.

User Avatar

Pop the hood, look down between the radiator the the front of the engine. should be plugged in the rusty exhaust pipe with an electrical cord that should be purple going to a plug on the right side of the engine.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.