Want this question answered?
Iver johnson
front trigger fires right barrel. back trigger fires left. boone
The forstock of the gun snaps off. There is no lever, you just pull it. Then break open the gun. The barrel then lifts out. You should now have three pieces: barrel, forstock and stock with trigger mechanism in place.
double trigger and hammers
MAKE SURE THE GUN IS UNLOADED AND THE MAGAZINE IS REMOVED! Cock the hammer down into the firing position. Pull the forward most point of the triggerguard down away from the slide. (You'll see that the triggerguard is on a hinge.) While holding the triggerguard down, pull the slide back as far as it will go and then lift the rear of the slide up slightly, off the pistol body. Lastly, the slide will still be rung around the barrel; just slide it all the way forward off the barrel and the slide will be removed. Take care not to lose the few little parts/springs that are not fully attached to the pistol body. When reassembling, put on the spring noting that the end with the smaller diameter goes on first over the barrel. Simply slide the slide back over the end of the barrel pulling all the way back, and with the triggerguard pulled down, press down on the slide and let it come forward back onto the pistol body. This can be a little tricky, but work it gently and it will happen. Make sure to press slightly down on the rear of the slide when joining the slide back onto the pistol body and also be sure the front of the triggerguard is pulled all the way down.
That was called the 'Semi-Hammerless' and made from 1905-1910. sales@countrygunsmith.net
i have a champion 12 gauge by iver johnson with a 36 inch barrel
The back one is for the left hand barrel and the front is for the right hand barrel.
action, barrel, trigger,sights, hammer
I have a 12 gauge shotgun with the numbers 4041 on it. It has a double barrel and double trigger and hammerless. Could someone tell me what year it was made?
Disassemble to do what? To remove the trigger group you need to push out the two pins in the receiver to remove the trigger group. To remove the bolt you need to take the barrel off which requires an armorers barrel wrench.
Its value is undetermined.