If you know the voltage and current then you can solve for the power:
P = V*I
Compute the open load voltage of the current source across its shunt resistance.This voltage becomes the voltage source's voltage.Move the current source's shunt resistance to the voltage source's series resistance.Insert the new voltage source into the original circuit in place of the current source.
RPS is only the voltage& power controlled device. it can only used for set the input for our wish A device which can change its output according to the voltage supplied to it is called a voltage controlled device.ex. a voltage controlled current source,or a field effect transistor. In a voltage controlled current source the output current changes as the voltage supplied to it changes.
You do not need ohm's law to relate power to current and voltage. Power is current times voltage. If you know current and voltage, you do not need to know resistance.
CC gives only current gain, but no voltage gain; gives only limited power gainCB gives only voltage gain, but no current gain; gives only limited power gainCE gives both voltage and current gain; gives large power gain
A transformer can only increase or decrease the voltage of an alternating current, and it is called step-up transformer or step-down transformer accordingly.
Induction occurs only with alternating current.
It depends by how much it changes. Power (watts) = current (amps) x voltage If the current halves and the voltage doubles, the power won't change. But if the current is cut in half and the voltage only goes up by a little bit the watts will go down. If the current only goes down a little bit but the voltage doubles, then the watts will go up.
battery
Voltage = (current) x (resistance) Current = (voltage)/(resistance) Resistance = (voltage)/(current)
Voltage = (current) x (resistance) Current = (voltage)/(resistance) Resistance = (voltage)/(current)
Its not voltage that kills it is current.High voltage CAN kill, if it can also provide high current (especially if the current comes near the heart as it takes under 1mA to stop the heart which isn't much current).However if the high voltage source is current limited and/or the current only passes through the extremities it is very unlikely to kill.
Voltage Tarnsformer transforms only voltage. While power transformer transforms both voltage and current.