0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
If you multiply amp times ohm the answers will be in units of?
Volts. Using the equation V=IR Change in voltage (measured in volts) = Current (in Amps) * Resistance (in ohms) So a volt equals amps times ohms.
How can you measure the electrical units?
Electricity is measured with a volt-ohm-amp meter.
Can 8 ohm speakers on a 4 ohm amp damage them?
Sorry, there is no amplifier with an output impedance of 4 ohm on the market. Scroll down to related links and look at "Interconnection of two audio units". Look for an amplifier and a loudspeaker.
How do you convert an 8 ohm car audio amp to a 2 ohm car audio amp?
you dont
Is running your amp at 1 ohm bad for your system?
Only if your amp is rated to handle a 1 ohm load. If it's not you WILL... fry your amp.
Can you wire two 4 ohm subs to one 4 ohm amp the amp is only rated for 4 to 8 ohm load?
There is really no 4 ohm amplifier. The output impedance of a good amplifier is less than 0.5 ohms. Scroll down to related links and look at "Voltage bridging or impedance bridging - Zout < Zin - Interconnection of two audio units".
Can a 4 ohm bridged car amp handle a 2 ohm speaker with proper amp cooling?
nope
Will 8 ohm sub woofers work with a 4 ohm amp?
if you put 2, 8 ohm speakers together on the same channel you will trick the amp into seeing a 4 ohm load, it is not advisable to run a 8 ohm coiled speaker on a 4 ohm amp unless you do the above. So if you want to run 2 8 ohm speakers from a 4 ohm amp this will work the best although the amp will need to be hefty as its worse to underpower a sub than overpower it! I have used a 8 ohm speaker myself on a car amp and had no problems but it was not a cheap entry level amp! some amps will take it, others will get hot and enter protection mode. Hope this helps!!!
What size amp do i need for two 10 inch kicker comp's?
You could go with a 600 watt 2 ch amp or a 300 watt mono block amp, depends on what OHM the subs are, if they are 8 ohm you could wire them down to 4 ohm or if they 4 ohm u could wire them to 2 ohm, i have a 600.1 Boss amp and subs are wired together at 2 ohm and they BANG.
Can you overload a channel on a amp?
Yes you can burn a channel on an amp. Which is do to a overload. Like a 2 ohm load on an amp that is not 2 ohm stable. Will burn out a channel or both channels.
Can you use a 6 ohm and a 16 ohm speakers with a 6 ohm amp?
No. Not and maintain good balance and dynamic range.
Your Amplifier for your 600 watt sub is cutting out The peak in the amp is 600 watts How do you get it to stop cutting out?
you ohm load is too low. raise the ohm load or buy an amp that is stable at the ohm level of the sub.
