0
If your bright high beam headlight on driver's side doesn't work but the low beam does do you still need to replace bulb?
Wiki User
∙ 15y ago
Use your voltmeter. Pull the headlight. You'll notice three prongs coming out of the bulb--one's for high beam, one's for low and the third is ground. Connect the negative lead of your voltmeter to a ground--the front bumper works--and the positive to one of the three prongs. Turn your headlights on and test for voltage on the prongs. One will have voltage; that's the low beam. Now turn your high beams on and check the connector for voltage again. If there's power at the socket replace the bulb--you can't change one filament in a sealed beam bulb. No power? Broken wire, bad socket or bad switch.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you solve a Wacom Bamboo Fun drawing when hovering?
Do these if each step doesnt work, 1) Re-Install the drivers after uninstalling the current drivers, 2) Replace the nib, 3) Disassemble the pen, 4) Replace the pen, 5) Replace the tablet.
Why doesnt the headlight taillight and dashlight come when the light switch is turned?
Probably a bad headlight switch. Also may be the power feed wire for the headlight switch. Check both.
What channel on bright house has horse racing?
it doesnt, brighthouse is horrible
How old is nikc Jonas?
He's 16 and has his drivers license, but Joe still doesnt
How do you access the low beam headlight bulb on a 2003 Mitsubishi Eclipse?
Passenger side or driver side? BClear. The low beam is built into the same bulb as the high beam. Just pull the bulb out from behind the housing under the hood and replace it. If the low beam doesnt work you have to replace the whole bulb. They're not very expensive.
Why doesnt my microphone work on windows 8?
Your microphone is not working on Windows 8 because it lacks the drivers. Try updating the drivers and start again.
Where is the smog pump on 1999 Malibu?
The smog pump is located behind the headlight on passenger side of car in the 1999 chevy malibu v6 3.1. I know this cuz mine is "possessed" and doesnt like to shut off. I actually had to unplug it. Of course inspection is coming and i will need to replace it soon.
How do you replace the horn on a 1992 Mazda 323?
you need to remove the plastic grill, followed by the passenger side front headlight assembly. the horn is a small dual disk looking device, remove the single bolt holding it to the vehicle, unplug, and remove. if that doesnt fix it, you may have a wiring problem
Can you drive with a light on?
You can with these exceptionsyour surrounding isn't pitch black, meaning there is street light on, your headlight onthe only light that can be on is the back section, not the driver sectionmake sure the lights glare doesnt block any visionthen you can drive with a light on, not so bright that you can't see a stop sign clearly or any road signs clearly
Why doesnt drivers license need an apostrophe?
Because it's not actually "drivers license." It is actually a driver license. However, if it were driver's license, you, indeed, would need the apostrophe.
Why doesnt a 2000 Chevy lumina operate at normal temperature?
Replace the thermostat.
Why does 1992 Nissan 240sx low beam headlight on passenger side not working when high beam works. Drivers side highlow works fine. Swapped bulbs and verified power to socket.?
well i think its the relay cause if one works and the other doesnt cause when the magnetic field is activated in it it will make the throw switch to the other pole
