answersLogoWhite

0

What water are you talking about? Water under the sink, yes! Water because you're pregnant, no!

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How can I properly install a faucet water supply line?

To properly install a faucet water supply line, first turn off the water supply. Connect the line to the faucet and the shut-off valve using a wrench. Make sure the connections are tight to prevent leaks. Turn the water supply back on and check for any leaks. If there are no leaks, your faucet water supply line is properly installed.


Will over flowing river water wash away sand from beaches?

yes it will as the water from the ocean goes back to the sea it will take a little by little as it travels back and forth to the ocean and shore


How long does it take for your vagina hole to close back up?

If what you mean by close back up, is get tighter after intercourse, or the time it takes for your vagina to retract back after continuous intercourse, it usually varies with every woman. If you are looking for a quicker method for that closness or (tightness) of the vagina, you can always put vinegar in your bath water and soak for a little bit. This will contribute to bringing the vagina tighter.


How can I properly install a fridge water line fitting?

To properly install a fridge water line fitting, first turn off the water supply. Next, connect the water line to the fridge's water inlet valve using a compression fitting. Tighten the fitting securely with a wrench. Turn the water supply back on and check for any leaks. If there are no leaks, your fridge water line fitting is properly installed.


How can I connect the water line to the back of the fridge?

To connect the water line to the back of the fridge, you will need to locate the water supply valve near the fridge, attach a water line to the valve, and then connect the other end of the water line to the fridge's water inlet valve. Make sure to tighten the connections securely to prevent leaks.


How can I properly install a sink water supply line?

To properly install a sink water supply line, first turn off the water supply. Connect the line to the faucet and the shut-off valve using a wrench. Make sure the connections are tight to prevent leaks. Turn the water supply back on and check for any leaks. Adjust as needed.


What do you do when your water won't drain properly and sewage leaks back into the basement?

Sewer line is clogged or collapsed. With a septic tank, it may need to be pumped out.


When you fill radiator with water the water leaks out from the back of engine on your 1994 Nissan altima what cold be the problem?

Sounds to me like a cracked head and or a blown head gasket, i had a similar problem but it was on a Saturn


Who is Holden on Pretty Little Liars?

Holden is a close friend to aria and spencer they go way back


How can I repair a bathroom sink?

To repair a bathroom sink, start by turning off the water supply and removing the sink stopper. Check for any clogs or leaks in the drain and pipes. Replace any damaged parts, such as the faucet or drain assembly. Reassemble the sink and turn the water supply back on to test for leaks.


How can I prevent diaper leaks from the back?

To prevent diaper leaks from the back, make sure the diaper is snug but not too tight, check the fit around the legs, and consider using a diaper with extra absorbency in the back.


How do you re-pressurise your water system?

To re-pressurise your water system, first, turn off the water supply and locate the pressure gauge on your system. If the pressure is below the recommended level (usually between 1-1.5 bar), open the filling loop valves to allow water into the system until the desired pressure is reached. Once achieved, close the valves and check for any leaks. Finally, turn the water supply back on and ensure the system is functioning properly.