answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2008-12-27 04:46:10
2008-12-27 04:46:10

Check the park lamp relay. It is probably next to the fuse.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions





Why is your 97 cadillac deville instrument cluster not working?


Try and replace the blinker switch. Iits a round thing under the dashboard on the fuse panel. It should be clearly marked.


If the blinker is not working on a Mazda 121, check the turn signal flasher. If the bulb needs to be replaced, remove the lens cover and insert a new bulb.


If you Mac is slow after installing Mavericks simply do an incremental backup after you finish working.


Left sinal not working in trailer hook up ?


re: need helpi need help installing a pioneer CD player into a 1990 Toyota corolla i installed it and the CD plays but the volume doesn't working and the blinker wont signal on its own i have to keep clickn


The dash indicator goes out to let you know one of the external lamps are not working


when you flip your blinker on, a relay in the circuit is activated which turns the light on and off. also, the front blinker and rear blinker usually alternate in turning off and on, so when the back is on, the front will be off, and reverse.. that's why when a bulb is out, the clicking sound in the vehicle goes faster than when both are in working order.


the light burnt out and you need a new one?



Each instrument used in analytical chemistry has a useful working range. This is the range of concentration (or mass) that can be adequately determined by the instrument, where the instrument provides a useful signal that can be related to the concentration of the analyte .All instruments have an upper and a lower working limit. Concentrations below the working limit do not provide enough signal to be useful, and concentrations above the working limit provide too much signal to be useful. When calibrating an instrument for use, the experimenter must be familiar with both the lower and upper working range of the chosen instrument.


Left and right stopped working? Check the fuse and/or the flasher relay. Only the left or the right stopped working? Check the bulbs.


Replace the tail light bulb from inside the trunk after pulling back the carpet. This should probably fix your blinker too.



Check the bulbs, check the fuse, check the flasher relay, in that order.



Chances are very good that you have a bad ground wire on your trailer or on the connector. Check the connector for rust or rot, clean the pins and use some grease to prevent future problems. If the problem isn't at the connector, you may have a bad ground on the trailer which could be anything from an ungrounded light socket to a bad ground wire. Hope this helps


When blinker is blinking too fast it usually means one of your turn signal bulbs are burnt out. Check if bulbs are working. If not replace blown bulb.



A burnt out signal bulb, a faulty blinker relay, a faulty blinker switch, a loose connection or a broken wire are all things that can cause the turn signals not to operate properly.



Fuse is blown light connector is unplugged ground wire on trailer disconnected



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.